Noise when washer is in spin/rinse mode

How To Fix A Washing Machine Making Noise During The ...

removeandreplace.com/.../washing-machine-making-noise-during-the-sp...

Jul 27, 2015 - Agitator directional cogs aka "agitator dogs" (top load washers) ... If you hear a rubbing sound or the drum spins uneven, then the ... A washer making a loud noise during spin cycle can also be caused ... The clutch in a washing machine connects the inner wash tub to the ..... May 8, 2015; High Water Bill?

Dishwasher Making Loud Grinding Noise During Wash Cycle

removeandreplace.com/.../dishwasher-making-loud-grinding-noise-durin...

Apr 11, 2014 - Dishwasher Making Loud Grinding Noise During Wash Cycle ... GE, Whirlpool, Frigidaire, KitchenAid, Maytag, Kenmore, and LG) this is a .... Our Amana dishwasher is making a loud, high-pitched squealing noise throughout the wash ....Out Of A Washing Machine - Top Load & Front Load September 30, ...

All comments on Loud dishwasher Frigidaire Gallery mode ...

https://www.youtube.com/all_comments?v=v-arYb20kOk

My Maytag Performa makes a grinding sound when it agitates. When it starts to dump the water it makes a loud grinding on metal sound... really loud. What is the problem and how much to fix?

I have the same type washer and it is about the same age makes the same grinding noise as the above mentioned one. Did this person ever find a solution?

The transmission might be going bad.

No, not if the noise is only when rinsing, if it makes the noise when spinning generally then possibly but if only noisy when rinsing sounds like a filter blockage on the waste pipe. clean out the filter behind the flap on the bottom of the front panel

if it's making a noise then either your drain pump bearing is going out or your thrust bearing is going out (assuming the noise happens in both spin and wash). Tip the washer backwards so that you can get underneath of it. Take the belt off and spin the pump pulley on the right side. This should spin effortlessly.

The middle pulley is the trustbearing pulley. Spin this--- one direction it should have a little bit of resistance--- the other should have more resistance

Sounds like the water pump is going out on it. The part runs about $80 and should only take about 45 minutes to install.

check water pump

Hi ksdoney.

Chances are there is just something in the pmp if you take the 2 black hoses off the pump you will be able to see if there is anything in it. hope this helped

Brent

This washer is JUNK!!!!!! We have the same washer (2 1/2 years old) and same problem. Tried to replace the bearing myself, no luck. So I called a repair man to come out and look at it. As soon as i told him the model number, they would'nt even come out. Very common problem for this washer. We are on our way to Sears to purchase a Kenmore.....GOOD LUCK