How toreplace door seal
SOURCE: Bosch Maxx WFL 2260
Hey check to see if you can move the drum by hand,, if you cant the the bearings on the drum have gone and it is seized ..
If you can turn it by hand then most likely it is the carbon brushes on the motor..
hope this helps
any questions dont hesitate to contact me im here to help....
SOURCE: Door seal replacement
1 Open filter cover and remove screw,slide plastic to right and remove.
2 Remove 2 screws from door hinge,lift and remove door.
3 Remove spring tensioned wire from groove in rubber door seal and ease rubber off front cover
4 Remove soap dispenser and remove the screw this reveals.
5 Remove 2 screws from bottom of front cover.Push cover upwards and remove.
6 Place to one side being careful not to damage wires to door switch.
7 Remove spring holding rubber to drum and ease off rubber door seal
8 Replacement is a reverse of the above
SOURCE: bosch maxx wfl 1300 washing machine that wont start.
hello could be brushes on the motor. there are 2 black clips that sit on the motor after time these whare down just slide them out and slide new ones in good luck
shaun
SOURCE: washing machine i not draining out. bosch maxx
two possible reasons that you dont drain pump is blocked or to much soap,
1,602 views
Usually answered in minutes!
1.while it was working it has high temprther with very hot water??
2.and now machine has stoping sotting tast only gining mathin sound?
×