Center channel is not working
Hold 'fm/am' and 'input mode' and press power button. Then cycle through menus using 'program' button until you come to the selection that says "preset inhibit". Then press 'preset/tuning' button to change it to "preset reservd". Then press power button to turn it off. When you turn it back on, it should be back to factory settings.
SOURCE: Yamaha Receiver Rear-channel Problem
Have you ever used the headphones as the sensor switch could be dirty?? Or if not mybe got a glitch in the micro from a surge or something like that. Try unplugging for a good few hours and restarting again???. Good luck Let us know as the more info we get the better we can assist you.
SOURCE: factory settings
I only found this on the manual
"...
if the power is cut for more
than one week, the parameter value you edited will
return to the factory setting."
SOURCE: Microphone for my YAMAHA HTR-5440
Let me make this clear to you that your Yamaha does not support Microphone but the trick is you can still do it. All you need is a stereo jack to a RCA connector cable.Check this out http://www.mediacollege.com/audio/connection/jack-stereo-rca-2.html It is easily available in the market. The stereo jack will fit into your microphone and the RCA to your Amplifier/Reciever. Plug the RCA into CD/Tape input but not in the Phono n do your thing. Let me know if this works,coz I'm really curious.
SOURCE: HI I have a Yamaha
In order to restore the unit to factory settings:
This will restore all factory settings.
For a digital copy of the owner's manual please reply in this thread.
1,484 views
Usually answered in minutes!
×