Hp 3600 54.17 error

While trying to connect your printer to your device, you may come across a popup box saying the HP printer is in an error state on your computer screen. But you can take the help of following easy steps to fix HP printer in error state issue. First, check the physical connections and ensure your printer is properly connected to your computer. Make sure your printer is not on an offline mode. Verify you have loaded the paper into the input tray correctly. Moreover, uninstall your HP printer driver and re-install it. If your printer is still showing in the error state, call HP customer support right away. https://connectmyprinter.com/how-to-fix-hp-printer-in-error-state/

If unit is under warranty HP will help you for about a year. After one year they have a get bent attitude and you will have to "google" the error code and see what you come up. Trust me you will find links re the situation. Think you are the only one going through the same sh**?

I would turn off the print and then turn on. This could be a main board issue.

when you try to print does it come up with any error message?

or does it get sent to the print spooler and then lost in cyberspace?

or does it get to the printer and then the printer says no?

for the error message follow what it says so if the error is no connection check that the wires are attached. if it comes up with an error code look it up on the HP website.

if it gets lost in cyberspace try reinstalling the printer with an updated driver.

and finally if it says no go to run and type services.msc and scroll down the list till you see print spooler if it says it is stopped start it and try again, if it still doesn't work try updating the firmware

Check the connections between the reader controller PCB and main
controller PCB. Check the power supply of the reader.

please disconect the printer for 5 minutes from the e-socet then conect it and try, if it still not work deinstallate the drivers and reboot the computer then installate the driver's from the samsung download site to your download folder first so they are availebl later again then installate the printer driver and the scanner driver and Dr. Printer an reboot the system again now check it should work proper now.

Try using the HP Scan Diagnostic Utility in Windows - HP Customer Care (United States - English).

If you need more help come back.

Post / thumbs / testimonial are welcome!

Boot from HP Diagnostic Media (SmartStart CD)and check the status of Array.....or harddrives...
If showing any failed status or not supported..
Replace drives to check if new drives show status...
It could be because of Drives not intialise for Array..

Boot to Array Configuration Utility...during bootup and go to Intialise disks....
Use them

Most likely, the main logic board has failed.

You might get lucky and find that it's only a corrupted flash, but that's a slim hope.

Steve W
LazerTek LLC

Service Call 188: Error: Sub-CPU Communication Error
1- Check the connection of the S2M board.
2- Replace the S2M board.

If the problem does not go away after a reboot you'd better call Oki (it should have a 3 yr. waranty) or an experienced oki technician.
This is not something you should want to fix yourself. The replacement of the s2m board is not an easy task (even for an experienced mechanic)