I have the Bissell ProHeat 7901 series and I just bought it 2 days ago it worked fine to do my carpets and when I took it over to my parents house to shampoo there carpets I got the machine ready to shampoo.I turned the machine on and the brushes moved for about a minute then the brushes stopped.I opened the belt access door and the belt looks good and not broken. In my manual it says there is 2 belts a brush belt and a pump belt. Where is the brush belt and pump belt located.and which belt am I looking at when I remove the belt access door.Also how can I fix it so that the brushes work again. please help ASAP
Make the machine safe from the power source first
When you remove the belt access door you are looking at the pump belt,
To gain access to the brush belt you must turn the machine over and remove the brush at the bottom of the machine.
there are two screw in the red retainers at each side of the brush, remove the screws and the retainers and the pivot arms ,you should see the brush belt and the pump
SOURCE: Water will not come out to do floor work
UPDATE! I changed the pump on my Bissell Pro-Heat 7901-1. This corrected the problem.
Pipert
666 views
Usually answered in minutes!
brushes worked fine, heard a loud click then found small spring on the carpet. took steps contained in the manual but brushes still not spinning.could the spring be from the machine which is quite new
it appears to have all belts but brushes are not turning only manualy
y
×