The machine goes thru the cycle until it gets to the final spin. The final rinse water starts to pump out, but the machins turns the water fill back on during the drain pumping. Then the machine spins with a load of rinse water in it that can't pump out because the drain pump stopped with the start of the spin.
1,567 views
Usually answered in minutes!
Premm, Please pay attention to the problem before you blurt out a "fixall soluion" that has absoutly no relevance to the situation!
Again, the water pumps out fine if the feed valve is closed. The machine thinks it is supposed to turn the water on when it does the final spin. WHY DOES IT TRY TO REFILL THE TUB WHEN IT TURNS ON THE PUMP?
On rinse cycle the machine will not rinse and water does not drain.
machine does not fill on the rinse cycle
The water filled up, the lid was closed and then the washer turned off and now will not turn back on or go through a rinse, spin cycle, and will not drain.
my hoover washing machine start the wash normal, but it does not complete the wash.before it goes into rinse the time saver light comes on and the machine stop turning. I tried to switch to spin or drain but its not working
Machine won't drain from final rinse cycle to then move to drain and spin
Low water on rinse cycle until you reset start/stop knob
Shortly after a wash cycle begins, all indicator lights light up and beep incessantly until a button is pushed. We can bypass it by running a rinse and spin, but this is a constant problem.
not spinning out water on last rinse
fills up with water but will not start cycle .I can manually turn the timer to engage it in the drain mode turning it passed the wash cycle directly to the rince cycle and it will drain the water out and spin and stop.
WAshibng machine trips RCD when washing, usually at the filling stage. Machine will operate on spin/rinse cycle with no problem. Suspect it is the heater.
All indicator lights function. A few seconds into cycle (just as water begins to fill) the door lock disengages, the lock indicator light goes out and cycle stops. The door lock assembly seems the obvious problem. Is there a way to determine instead of guessing?
water enter, detergrent goes thru machine, cycle runs but noo movement
my washer operates normally in all other ways, but when I try to use the rinse and spin option it does not fill with water. There is noise but no water enters. The machine cycles, agitates and spins as if it were working but clothes come out as dry as they entered.
Red light comes on and i've check the filter/pump outlet which has been clear of debris but still no action from Washing machine. Red light flashes then goes constant but no water pumped or spinning at all.
the leds dims off while the water valve in opened
FINAL RISE PUMP WONT DRAIN WATER OUT
QWD
Stops at rinse cycle
Fills at rinse cycle and stops
when we programm for washing and start it rinse the water immediately
The cold water "fill" will not cut off and stop flowing into the machine during either the wash or rinse cycle
stops during rinse cycle and the water will not drain
When starting a load of wash water goes out the drain instead of filling up in the drum where clothes are, have to plug the drain hose and then it starts to fill, does in both when starting a load and when starting rinse cycle.
Where would the pump be and how to change?
could it be a pump bearing?
water doesn't enter
Machine fills with water. Completes the wash cycle and drains. It hangs when it gets to the rinse cycle. I can cancel the cycle and switch the machine to the rinse cycle and it will complete.
WATER DOESN'T DRAIN AND SPIN CYCLE DOESN'T START
it fills up with water but it will not spin it humms
Note: i tried only giving spin and rinse after getting this problem...it didnt work at all...it produces a weird sound
machine goes through it's cycle but does not spin.
machine goes through it's cycle, but does not spin.
the machine washes but does not want to spin, it only spins for 2 mins then starts filling with water.
×