Question about Washing Machines
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: error code FL flashes and
FL error - Flood condition
"FL" flashes if any overfill condition occurs. This condition occurs when excessive water in the tub causes the overfill switch to trip. The control must realize that the trip was due to an overfill condition instead of a suds lock condition in order for "FL" to be displayed.
With an overfill condition, the beeper repeats a warning every 10 seconds with no time out. The pump is cycled in drain mode for 30 seconds on, 30 seconds off until the overfill switch resets or power is discontinued to the unit. Press STOP/CANCEL to clear the display.
You coudl se this manual: Service_Manual_PDF
Hope this helps.
Posted on May 20, 2011
SOURCE: My washer won't start and
EBE and EBF are console control problems. This could be replacing the control board, rewiring, or replacing a part on the washer. It is always best to consult or hire a professional when you want to repair an appliance.
Please, use this video as reference guide, how to replace washing machine controls in a Hotpoint washing machine...
Posted on Aug 07, 2011
The ND error code means NO DRAIN. ,
The usually reason the door remains locked once the cycle is over is because the filter screen on the drain pump is blocked so not all the water could drain out...the door lock is tied into the pump and until the pump tells the control board that the wate r is out the door will not unlock. This tip i wrote will show ya how to take apart the washer to clean the filter on the pump.
Posted on Sep 23, 2011
Hello there and welcome to fixya
From what you're describing it sounds like the drain pump is blocked. The nd error code indicates "no drain". If the unit can't drain it won't spin. You're going to have to slide the washer out far enough to remove the rear panel; be careful not to damage the floor. Once you get the rear panel off you will see the pump. Be sure to have plenty of towels & a small container to catch water. I am sending you instructions from the service manual to remove and replace the pump. Another possibility is the drain line is blocked or something is stuck in the tub to pump hose.
Posted on Nov 05, 2011
Tips for a great answer:
Feb 16, 2017 | Whirlpool Washing Machines
Feb 11, 2013 | 2003 Dodge Durango
Aug 01, 2012 | Electrolux Washing Machines
Nov 05, 2011 | Amana Washing Machines
Sep 29, 2011 | Nintendo DS Lite Console
& Welcome to FixYa
I don't think it is any other board, I believe the CCU (central control unit)
has gone bad as it keeps on stopping mid cycle. If it was the Motor Control
Board (MCU) then the washer motor should have been causing problems (which isn't
the case) so replacement of CCU will be a great option. Please get back to me
if you have any other questions.
Sep 23, 2011 | Whirlpool Duet GHW9150P Front Load Washer
May 27, 2011 | Nintendo Wii Console
May 14, 2011 | Nintendo Wii Console
May 11, 2011 | Nintendo DS Lite Blue Console
941 people viewed this question
Usually answered in minutes!