Washer door opens with hinges on the left

Due to the shape of the washer door, and how it seats against the control panel, the door cannot be reversed on the Duet washer. There are no cut outs along the door opening to accommodate the door hinge screws and the door latch on opposite sides. The Duet DRYER, on the other hand, CAN be reversed. This may be an alternative configuration for you. Let me know if you want to know how to reverse the dryer door.

IN TH FRONT RIGHT OR LEFT CORNER OF THE DETERGENT AREA THERE IS RED, GREEN, ORANGE LIKE FISHING LINE FOR YOU TO MANUALLY RELEASE DOOR. THIS IS EASIER WITH PLYERS. PULL THE LINE DIAGONALLY TO THE LEFT BACK WHILE IN FRONT OF THE MACHINE AT THE SAME TIME PULL OPEN DOOR. IF YOU WANT TO DO MORE THAN GET YOUR CLOTHING OUT I WILL HELP YOU FUTHER.

Try using some J.B. Weld on it instead of glue. It will essential form a weld and should hold up better. You might want to give that a try. Good luck and best wishes.

The doors are reversabe they go from left hand open to right hand open. Just reverse the hinges, put the door fillers ( triangle shape go toward the front. Remove the plug put it in the other sidel. Now take the metal door strke and put it on the other side, Then take the filler from on side and put it on the other side. Takes 10 to 15 minutes to make the change.

No need to purchase another door!

Yes you can reverse the door on your washer.
Open the door, remove the screw in the middle of both hinges, (carefull not to drop them inside). Lift the door straight up and "wiggle" the door hinge straight out of the slot.
On the opposite side of the opening you will find two inserts, remove them and install them into the slots you removed the door from. Now the fun part... remove the hinges from your door side.
Make sure you note how they attach, now intall them on the other side of the door,EXACTLY, the way they were first installed. Do one at at time. After you have them on the other side and you put the other screws back in the side you removed the hinge from, lift the door and slide the hinge into the bottom and top slots of the washer opening. Secure the hinge with screws removed in the beginning making sure the door is closing properly and locking.

Don't you think it would really boost sales if you did make a washer that the front loader door could open left to right . For homes that have very limited laundry room. and no way to switch.

open up the door, on the left unscrew 2 screws at door, on the right unscrew 2 screws at hinge....pull cover out. you will see a hinge on the left and the right that holds down the top to the front panel, you will be able to lift up, you may have some hoses on the left you may have to unloosen to pull top all the way up..

For best washing for front load, i recommend Melapower He detergents.

you only use 1/2 fl.oz, works great! if you want to know how you can get it, contact me [email protected]

no you are stuck with the fact how they were buld.unless you want to mover the doorlock and all wiring and the hinge.
also have to make a hole for the doorlock.
I would not advice this.

Electrolux has a reversible door for both front load washer and dryer. Just found that out at HHGregg because we need to put our washer to the right of the dryer, and none of the other makes will allow the washer door swing to be switched.

I am looking for the same answer on the washer. You can definitly change the dryer. The holes are on the other side under black tape.