Check LInt Scrren Light is On and will not power on

What do you mean by this blank screen. A screen with back light only? A screen without any back light [dark screen]? Provide more details please. If you wish to get details about these type of faults to Sony LCD TVs, check this link.

The thermal fuse has failed. This is caused usually by extreme heat (due to internal or external lint build up).but can be caused by a componenet failure. I am using LEA10AW as the model number for parts reverence.
The thermal fuse is item 6 this link:
http://www.appliancepartspros.com/partsearch/model.aspx?model_id=19412&diagram_id=28449751#d28449751

Things you must check
1. Lint filter and cavity for lint build up. (Remove the lint filter and wash it in vinegar and water and soap and water) Fabric sheet particulate imperminates the screen. It can look clean but be 85 - 95 percent blocked with the particulate.
2. All internal and external ducting for restrictions.
3. The outside wall thru the wall vent flapper for lint build up. (Clean it!)
4. Check for airflow after replacing the thermal fuse and cleaning. The air-flow at the dryer vent outlet should push a relaxed hand gently away from the outlet. If it does not to this there may be a broken blower wheel hub or impeller blades. Blower wheel is item 8 this link:
http://www.appliancepartspros.com/partsearch/model.aspx?model_id=19412&diagram_id=28449750#d28449750

Thanks for choosing FixYa,
Kelly



Use a folded wire coat hanger and a vacuum to remove all lint in hard to reach places.

This is a problem with the power / Invertor board. Acer provides a 3 year warranty.
Samir

I had the same problem, Check Filter light blinking and beeping, could not select drying type or start dryer. Short story, turned out to be the Less time button was stuck pushed in. Long story, a week before I had replaced the drum rollers and belt, everything was working fine for the week after then this problem. Totally by accident, after trying all the recommended actions (unplugging, pushing buttons, etc.) leaning on the right front corner would stop the beeping and allow the machine to work. Pushing all the buttons, I found the Less time button would not click. Apparently, when I took the control panel off to change the rollers and belt I flexed the control panel enough to misaligne the button and switch. Pulling the back of the control panel loose and making sure the push button and switch were aligned and working correctly everything works fine now.

I am not familiar with your dryer, but it sounds like a safety mechanism where if your lint screen is not cleaned the dryer will not turn on. That "Check Lint Screen" light for your dryer may be connected to a sensor near the lint screen area. Check that out and see if that is the problem. If there is a sensor it could be faulty,

lint scrren on top ,,fuse in back lint screen inside dryer remove bottom panel remove 2 screws holding metal chute where lint screen sit right behind is thermal fuse

check belt might be broken,,,,

Another post reported replacing the power cord. I am trying to determine if this is a factory defect. Check the power at the power cord connections inside the dryer. You could have lost power on one leg and the other 120 volt leg is letting the light work. Let me know what the model and serial number is.
InMrFixIt

check for wires near lint filter casing. these are the lint filter sensors, they could be defective that is why it always indicate a clean lint filter alarm,

Do you get an Amber light on either monitor?