SOURCE: Fills with water and then stops and beeps and
Hi just read your posting.The 2 lights that are flashing means your machine has not detected any water level difference.1st turn off both hot and cold taps and 1st remove the cold inlet hose from the machine end,Put the end of the hose into a bucket and turn the tap on.You should get a good flow of water.If you do not get a good flow of water then remove the tap end of the hose and see if you are getting water out of the tap.Check the inlet filters on both ends of the hose to see if they are blocked.If they are blocked clean them with a brush.Check also the water valve end where the hose connected to the machine to see if this filter is blocked. Once you have water coming out of the hose and all the filters are clean refit the hose and repeat to the hot hose.Now select a cycle and push start.If the water flow is good then the machine will work properly.If you still get slow water even when you have good pressure coming out of the hoses then your water valves are faulty.Please reply on how you got on and for further advice.looking forward to your reply.
SOURCE: My 7-8 year old top load FP washer is slow to fill
check the water filters by the tap and the machine connection
SOURCE: the cold water only trickles
You will need to replace the "cold water valve" with this part.
SOURCE: My top loader washing machine
The inlet valve has failed & needs to be replaced unless you don't use hot water then you could just swap the hoses over.
126 views
Usually answered in minutes!
×