LOC ERR Washer began cycle, manually stopped the washer immediately as the dial was on Heavy, turned dial to normal. Upon completing this began to receive the LOC ERR with 3 beeps. Any suggestions would be greatly appreciated. Thanks

turn the breaker off for 5 minutes or unplug it for 5 minutes. then try
good luck
https://www.6ya.com/mrmmike

1. Turn the washer off.
2. Set the mode selector dial to NORMAL.
3. Turn the dial counter clockwise ONE click (LEFT), clockwise THREE clicks (RIGHT), counter clockwise ONE click (LEFT) then clockwise ONE click (RIGHT).
4. Now press the start button.
5. All the cycle indicating lights should be illuminated.
6. Press the Start Stop button once.
7. Rotate the dial until Rinse, Wash, and Stop light illuminate.
8. Turn the washer off and unplug it for 10 seconds.
9. Finally, turn on the washer and it should now be reset.
10. Run a test load empty to be sure the reset worked. If not perform the reset procedure one more time.

Check door switch: If the lid switch is bad it will not drain or spin. Try this test: With lid open let it finish wash cycle. Press lid switch down with screwdriver. Washer should begin draining. Release switch. Motor should stop. Press switch a second time. Washer should start spinning as it continues to drain. If motor doesn't come on while lid switch is pressed, replace the switch. OR
http://www.youtube.com/watch?v=q942xn_2VXY

Your door lock switch needs replacing.

If the water drains between the wash and rinse cycles, your motor and pump are probably OK. If this is a machine with a dial, try a different cycle, like normal instead of heavy duty. If that works and the machine completes the entire cycle then the timer probably has a bad spot. You might try to find a replacement timer if that is the case although I didn't have any luck with my 10 year old washing machine. Best of luck

The LOC code merely means the control responded and locked the door. You'll find a tech sheet under the top panel of the machine to help guide you thru the diagnostic process, which is fairly involved.

LOC means it thinks the control panel is locked. This gives the ERR indication when you push the buttons. To unlock it you need to hold down the Options and Select buttons together until it reacts.

I know this may seem silly but - On the top right back corner of your washer hit it with medium force with your fist, this helps.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

if it fills and agitates but stops at the drain/spin portion, it sounds like you have a problem with the lid switch. if it thinks the lid is opne, it will not drain or spin.

All the lights are on, but the door lock. We have unplugged it, doesn't help. Our washer is the front load, model LTF 2140ES0.

the timer change by itself. You don't have to change anything.
But cold rinse only works if you have the cold water connect to the washer