Blinking light cycle won't start

unplug count to 10 plug back in

push power button on push any cycle button hold down 3-5 seconds release push 4-5 times . if that don't fix it unplug for 30 min try that. let me know if it works might check lint trap also

Remove the lower panel and clear the filter.

Could you please describe the problem you are having a little better please?

I had to replace a drain pump motor when this happened to me and she has worked great ever since!

she paused the machine and its searching for a command,, unplug it and wait 5 minutes so it can reset,,

take the kick plate off and put your and inside u going to feel a little round tab in the door lock , just pull that tab and the door unlocks

UR MAIN CONTROLLER NEEDS REPLACING. IT HAS A COMMUNICATION ERROR

this means your drain pump is clogged--- there are 3 screws at the bottom of the lower front panel. Remove these screws and there is a drain pump cleanout located in the middle. Twist this off by hand can clean out the debris--- WATCH OUT LOTS OF WATER will come out so have towels ready.

Go to: RepairClinic.com

There you can troubleshoot
your appliance.

You'll need make & model #.