Question about Indesit W 123 Front Load Washer

Open Question

How do you take the lid off an indesit wixe 127

I have got the H20 on my machine. I have checked the inlet hose and the water flow is fine when disconnected as is the pressure. I can only think that the problem might be the inlet on the machine. I tried to look at it by removing the top. I undid the two screws but something is also holding the top from being lifted.

Posted by Anonymous on

Ad

5 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: My indesit wixe 127, wont

i think there is a problem with low water level sensor
My 127 fill up with water and i have f-08 error code which is a high level water sensor faulty

Posted on May 17, 2009

Ad

Anonymous

  • 1 Answer

SOURCE: Fabric conditioner not going

Check the solenoid belongs to that tray.It may struck.

Posted on Jul 05, 2009

taran_2005

taran_2005

  • 10515 Answers

SOURCE: Indesit WIXE 127 The machine is

Hi,

Demo Mode
If the machine is on Demo mode 'D on' will be displayed and the machine will NOT function.
To reset the machine for normal use:·
Turn the power off at the wall.
Push in and hold down the Start/Stop and the Start/Reset
buttons, while still holding down, turn the machine on at the
wall.
'D off' will be displayed and the machine will function
normally.

Let me know,if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!

Posted on Nov 20, 2010

seangosling6

Sean Gosling

  • 15 Answers

SOURCE: indestit wixe 127 is leaking water from under the

The only way you can find out where the leak is coming from is by removing the back and putting water in it. Using a torch try to see where it is leaking from. TBH its usually the door boot (the rubber seal around the inside of the door). As for the noise.... Open the door and take hold of the shiny part of the drum inside. (Just that bit). Try moving it up and down. If there is any play in it and it rocks a little that is your bearings going and can be an expensive repair. Hope that helps.

Posted on Nov 26, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Indesit 7105 has flashing H20 lights, have checked but no blockages. It fills and drains fine, It wont agitate though, any ideas?


The machine does not fill with water or 'H20' flashes in the display.
The water inlet hose is kinked. • The water inlet hose is not connected to the water supply. • The water pressure is too low. • The water tap has not been turned on to allow water to flow into the machine. • There is no water supply to the house. • The inlet valve filter is blocked. • The START/PAUSE button has not been pressed.

Faulty pressure switch machine thinks there is no water in the machine.

Apr 01, 2017 | Indesit Washing Machines

1 Answer

Why is code h20 flashing during the washing cycle?


The washing machine fails to load water (The wording H20 is
displayed).


• The water inlet hose is not connected to the tap.
• The hose is bent.
• The water tap is not turned on.
• There is a water shortage.
• The water pressure is insufficient.
• The START/RESET button has not been pressed.

Dado

Jul 12, 2015 | Indesit IWE91481 White 595 mm Washer Front...

1 Answer

Indesit washing machine showing H20


code showing h20 is the clue water is also known as h20,so your problem is the inlet valve letting the water into the back of your machine needs replaced or water pipe is kinked and no water is at the supply,. these valves are cheap at 10 dollars,adrian.....

Dec 20, 2014 | Indesit W 123 Front Load Washer

3 Answers

Code F-05 showing on INDESIT WIXE 127 washing machine. Not emptying or spinning.


Hi

Error code F05 means that the pressure switch is jammed on full.
Remove lower rear cover of washer.
Locate and remove the large black fastened to bottom of the drum.
Remove and clean plastic filter inside hose.
Remove hose onto pump, and check for blockage or obstruction here as well.
Hope this helps you.

Jan 03, 2011 | Washing Machines

1 Answer

Fault code h20 flashing on indisit wie127 washing machine


H20 is indicating a problem with the incoming water supply to washer.
Check the inlet hose/s for kinks or other restriction, ensure that you have a good pressure to the washer, make sure tap/s are fully turned on.
If all o/k,then could be a problem with the inlet valve/s
Please rate my solution.
Thankyou.

Jan 21, 2010 | Indesit W 123 Front Load Washer

1 Answer

Display periodically flashes H20


The faulot is related to the incoming water supply.
Chaek inlet hose for restriction or low water pressure.

Jan 19, 2010 | Washing Machines

1 Answer

Does not complete cycle comes up with -H20 on screen


Hi.
Fault code H20 is indicating that the washer is not filling correctly, check tap/s hoses, and inlet valves for water supply.
Please rate my solution.
Thanks.

Nov 07, 2009 | Indesit Washing Machines

2 Answers

Fabric conditioner not going


Check the solenoid belongs to that tray.It may struck.

Jul 05, 2009 | Indesit WA 125 Front Load Washer

2 Answers

My indesit wixe 127, wont drain and is stuck on error code f05. what doi do?


i think there is a problem with low water level sensor
My 127 fill up with water and i have f-08 error code which is a high level water sensor faulty

Aug 11, 2008 | Indesit Washing Machines

Not finding what you are looking for?
Indesit W 123 Front Load Washer Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Indesit Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

peter gittos
peter gittos

Level 2 Expert

247 Answers

jimorris77

Level 3 Expert

411 Answers

Are you an Indesit Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...