Question about Canon Pixma MP450 All-In-One InkJet Printer
Suddenly my Canon Pixmania MP450 isn't recognized anymore by my computer. It says that the usb device can not be recognized. I have tried it on another computer (laptop) on which it worked before as well and it has the same problem. I replaced the cable and still there is the same problem.
It does copy and print test pages by itself and when it's turned on it goes directly into copy mode.
I have no idea what else I can try. Anyone?
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Check your print defaults and make sure that the Canon MP450 is set up to be the default printer. If it still continues to be a problem than check the print cable by changing it out.
Posted on Feb 22, 2009
Tips for a great answer:
Feb 23, 2013 | Canon PowerShot A480 Digital Camera
Reset your GoGear with something sharp like the tip of a pen or the end of a paper clip,
if you're device isn't working properly or there's a frozen display.
Insert the sharp object into the "Reset" hole (located at the bottom of the player), and hold it there until the device turns off.
If resetting the device does nothing to restore the display, access the "Philips Device Manager" through your computer to recover the GoGear.
Click "Start" on your computer, then "Programs," "Philips Digital Audio Player," "Aria Device Manager," and then "Philips Device Manager."
This will launch the "Philips Device Manager." Make sure the GoGear is turned off completely. Connect your GoGear to your computer while holding down the "Volume Up" button.
Continue to hold the "Volume Up" button on your GoGear, until the "Philips Device Manager" recognizes the device and enters recovery mode.
Click the "Repair" button when it appears on your computer, then folow the steps to fully recover the GoGear.
Properly disconnect your GoGear from your computer and restart the device.
Recharge your device if your GoGear dies suddenly while playing.
Connect the GoGear to your computer via the supplied USB cord.
Plug one end of the USB cord into a functional, open USB port on your computer. Plug the free, smaller end of the USB cord firmly into the small USB jack on your GoGear and turn your computer on.
This will begin the charging process of your GoGear.
If recharging doesn't work, the battery may need to be replaced.
Check that your GoGear isn't in standby mode. Hold the "Power" button for two seconds to turn it back on.
hope this helps
Oct 07, 2012 | Philips GoGear ViBE SA1VBE08K MP3 Player
Aug 25, 2011 | Canon PIXMA MP530 All-In-One InkJet...
May 15, 2011 | Computers & Internet
Jan 12, 2011 | Canon MP450
May 31, 2009 | Dell Inspiron 6400 Notebook
Jan 27, 2009 | Canon Pixma MP450 All-In-One InkJet...
Nov 05, 2007 | Canon Pixma MP450 All-In-One InkJet...
Jul 13, 2014 | Canon Pixma MP450 All-In-One InkJet...
113 people viewed this question
Usually answered in minutes!