How to remove and install on/off pin for robot coupe r2

Wiring diagrams are in the back of the manuals after the parts lists.

https://www.partstown.com/robot-coupe/blixer-3b/parts#id=mdptabmanuals

..

you look for hidden screw perhaps under a label

To add the pulse button to your Robot Coupe R101, you will need to purchase the R101 Plus switch and front panel. The replacement is relatively simple and can be done by following these steps:

1. Turn off and unplug the Robot Coupe R101.
2. Remove the screws that hold the top cover in place and lift off the cover.
3. Locate the control panel on the front of the machine and remove the screws that hold it in place.
4. Carefully remove the control panel and disconnect the wires from the old switch.
5. Install the new R101 Plus switch onto the control panel and connect the wires.
6. Replace the control panel onto the front of the machine and secure it in place with the screws.
7. Replace the top cover and secure it in place with the screws.

Once the new switch and front panel are installed, you will have the pulse button on your Robot Coupe R101.

it takes two to do this. there are two holes on the bottom part of handle. find something strong to push them in. one person pushes them in and have other person with pliers pull on the plug that you need to remove to get to broken pin. after that...replacement is easy

It just a long shaft phillips screwdriver. The screws are located under the foot pads. They just pull out and then there are the four screws.

Robot-Coupe USA.com should be able to sell you anything needed

There are 4 rubber shoes on the bottom of the white or gray base. Twist & pull these out. With a TORX long shank screwdriver (nothing else works, trust me) there is a screw way down in each hole. After removing the screws a gentle but firm bump should loosen the base. If you ever need to replace the motor, on the top around the drive shaft you will see three round plugs/disks, remove them by prying up with a pocket knife (works best) this will give you access to the three motor bolts.

Remove the base the screws are under the rubber feet,on top of the machine there are three screw caps remove these with a bradel, unscrew screws with large torx screw driver, remove spindle anti clockwise by locking out fan at base. for all Robot coupe parts go to http://www.catering-machines.com/

That plastic piece is a sling disk or sling blade and made to sling product to the discharge chute. Believe it or not, the motor shafts wear out and could be the cause of premature failure. When you install the new sling blade, check to see how much slop/ play there is by moving this back and forth on the shaft, a small amount is ok (1/16th to 3/32nds). The other thing to look at is forcing or overfeeding the unit. You can contact them at Robot-coupeusa.com

Cindy,
Send me your e-mail & I will send you back an exploded view of your Robot-Coupe. It will give all the info needed. [email protected]