My washer works on all cycles it even agitates and spins during the cycles in wash and rinse, but when It gets to the final spin cycle it stops and won't spin.
SOURCE: Washer doesn't agitate
sounds like your washer went mellow on you(doesn't get agitated, right)?
ok. enough humor.
sounds like there's a problem with the motor/belt/control board in that order
SOURCE: Washer fills, drains, & final spin
I had the same problem and ended up replacing the control board which solved it. Contact Westland Sales at 800-356-0766 ext. 5 for tech support.
SOURCE: Will not spin on any rinse cycle
Hi, This washer does not have a belt. While the washer is agitating, if you lift the lid will it stop? Some models will agitate but not spin if the lid is up. It sounds to me like the lid switch might be going bad.
If you will get me a model #, I can look this up for you and give you a better idea.
Vic
SOURCE: top loading whirlpool washing machine agitates but
Some have two belts and one could be off the pulley or if not a coupling on the motor shaft may be cracked or broken.
SOURCE: Agitator won't spin during wash/rinse cycle. It's
Hi,
There could be several reasons for washer not to fill .Fill washer with water and wait for the timer to get to the drain mode.Unplug the washer from the electric outlet.Open the case, and disconnect the water hose from the outlet of the water pump.If you get water pouring out from the pump, then plug that up and check the hose to the sewer. If that is clogged, then you have found the problem.Some washers have a self cleaning filter in that hose somewhere. Check that to be sure it is working properly.Reassemble hose from step 3.Plug washer back in. If it pumps out now, then you are done. If it doesn't, then the water pump is probably defective, so replace it.
Thanks for contacting Fixya.com
1,561 views
Usually answered in minutes!
after wash circle it stop even light is on
the whirlpool washer does not fill up in any of the rinse cycles. The wash cycle works fine
The washer stops before doing a final spin drain cycle. It just sits there with timer counting down. If I then power off and set it to spin/drain cycle it is able to complete successfully.
Mxw300x stops at end of wash cycle, and won't rinse and spin
×