This problem is most often caused by a defective washer lid safety switch, pull the top un and bypass the lid switch, if the washer operates normally replace the switch.
You need ... Lid switch assembly Manufacturer Number 3949247
SOURCE: Whirlpool Ultimate Care II washing maching but will not spin.
lid switch is bad chance are you can by pass this by removing the timer header and crossing the outer wire on the lid switch that it mounted closest to the lid not the power cord this will tell you if you need a switch
SOURCE: Whirlpool Ultimate Care II Plus Washer Model: LSQ9264HZ0
if you hear the motor running while it is supposed to be agitating or spinning then it is most likely the direct drive coupling between the motor and transmission. if you already checked this and think it is a different problem then let me know, i will help you figure it out. Mike
SOURCE: Whirpool Ultimate Care II washer Imperial Series spins at low speed
it sounds like a worn clutch.
SOURCE: Lid Switch
hithanks for the question The lid switch is located under top on right side if you open the lid you will see a small plastic plunger on the lid this plunger is what activates the lid switch Thanks for your question hope thisanswers your question The appliance doc
1,628 views
Usually answered in minutes!
×