Hi davemac918...
I used a long pair of tweesers to grab the filter, but you can also grab it with a piece of wire with a hook bent on the end of it large enough to fit the tubing the filter is inserted into.
Hook the filter tubing, and pull the filter to the top of the tank and manuver it out of the tank.
Please take time to rate me
You can buy the whole kit at home depot
Http://www.searspartsdirect.com/partsdirect/Grass-line-trimmer-help/Replace-the-Fuel-Line-on-Your-Grass-Line-Trimmer
I’m happy to help further over the phone at https://www.6ya.com/expert/william_83fc156eee2b555e
You would be well advised at that point to change the filter, fuel lines and primer bulb. It will save lots of headache in the future.
http://www.ereplacementparts.com/articles-c-8873.html
SOURCE: craftsman 32cc would not idle
If you are certain that you have correcting gaped the plug then the next step is to readjust the low end idle carburetor. If you look you should see two holes in the plastic cover that lead to the flow adjustment screws they may even be out in the open. If they are not labeled H and L (the L is the one you want), check your manual for the correct one. A good place to start is turning the screw all the way in then backing it out 1 1\2 turns. Then check it. If you still have problems do 1\4 turns out. After about one full turn from that you might want to consider taking the carburetor off and removing the float bowl or the bottom for a good cleaning. A sticking float could cause problems with your fuel flow.
Hope this helps.
1,570 views
Usually answered in minutes!
×