Kenmore 24032\24036 Top Load Washer Logo
Posted on Sep 05, 2008
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Ordor from washing machine

I have an ordor coming from my washer. How is the best way to clean it. It is a Kenmore 90 series, heavy duty washer, top load.

2 Answers

realjeep

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 12 Answers
  • Posted on May 08, 2014
realjeep
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

Joined: May 03, 2009
Answers
12
Questions
1
Helped
4251
Points
26

I fixed the bad odor problem once and for all!
This problem is caused by mold and mildew growing in a large ventilation hose that runs from the top of the wash drum to a large vent hole in back of the machine.

To correct this problem you can buy a kit from http://washerfan.com/ or do the cheap fix like I did.
Step One: Find the vent grille on the upper left corner of the machine. Remove the machine top, only a couple small screws hold it on.
Step two: Remove the hose clamps that hold the hose to the drum and grille then snap out the plastic grille.
Step three: The grille is convex so I used a belt sander to make it flat then I took a computer case fan that was the same size as the grill and hot glued it to the plastic grille. I wired it to an old 12 Volt phone charger (12V 500 Ma) and made it blow air INTO the vent.
Step Four: Put everything back together and enjoy a stink free washer because the mold can no longer grow in that hose.

Note! You must bleach, clean and scrub that crud out of that large vent hose and it is some kind of gross! If you're allergic to mold please wear respiratory protection. My fan has been blowing air into the washer 24/7 for six months and I have seen those case fans run non stop for years. It it dies just snap the hot glue beads and put another fan on it. Total cost for the entire fix, about $10.00

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Novelist:

An expert who has written 50 answers of more than 400 characters.

Governor:

An expert whose answer got voted for 20 times.

  • Expert 166 Answers
  • Posted on Sep 05, 2008
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

MVP:

An expert that got 5 achievements.

Novelist:

An expert who has written 50 answers of more than 400 characters.

Governor:

An expert whose answer got voted for 20 times.

Joined: Sep 04, 2008
Answers
166
Questions
0
Helped
43170
Points
348

Peace,
Ngafm at your service,

If you run the washer once a week without clothes and use 1/4 cup of bleach with hot water it will more than likely stop the smell problem!
But after you do the be sure to do white clothes next so no bleach
stains a spot on an article of clothing as happened to me!

AND , leave the washer door open when not in use!
If the smell persists, you may want to call service to make sure all the water is being pumped out and there is no wet lint standing in the pump or drain system of the washer!
Some loaders may have this smell problem on occasion if water is left standing inside some the washer some where!

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

70 Series Kenmore Washer Agitates in Heavy Duty regardless of switch selection

Yours is a 2 speed motor. Does it spin in 2 different speeds. If so, then it most likely is designed with only to agitate in 1 speed. If it only spins in one speed, then your motor is defective
0helpful
1answer

Kenmore 90 series washing machine, heavy duty, super capascity plus,quiet pak2 3spd motor w/5spd combo, when in spin mode, it smells like melted crayons

If drain hose is connected to a standpipe check that it's inserted no more than 4". You may be getting a syphoning situation that is allowing gray water to contaminate clean clothes.
0helpful
1answer
0helpful
1answer

Bad ordor

you need to remoc=ve the lid then the control panel and then remove the front panel and you can get to the inside of the machine
0helpful
2answers

Washer has ordor

run a cycle with a heathy amount of bleach on hot. Odor is usually due to bacteria or somehting left behind. Is there any filter that can be cleaned??
Jer

0helpful
2answers

I have an old Kenmore Heavy Duty 70 series washer.

its a filter inside the water hose thats still blocked or the relay inside the washer for the cold feed is not opening up fully it could just need a clean or maybe a new one fitted
12helpful
2answers

Kenmore 90 Series Heavy Duty Washer - Agitator doesnt spin

THIS IS A TYPICLE PROBLEM . BETWEEN THE MOTOR & THE TRANSMISSION THERE IS A COLLECTOR ASSEMBY (THREE PIECE
SET) REAL EASY TO GET TOO EASY TO FIX . ALSO COST EFFICENT
1helpful
1answer

Washer works but smells like its burning.kenmore 90 series heavy

The burning smell could be the motor going out. When the water gets into the tub and makes it heavy it puts strain on the motor and the motor may be getting weak.
4helpful
1answer
Not finding what you are looking for?

153 views

Ask a Question

Usually answered in minutes!

Top Kenmore Washing Machines Experts

Alexander

Level 2 Expert

171 Answers

Cindy Wells

Level 3 Expert

6688 Answers

vince

Level 3 Expert

2530 Answers

Are you a Kenmore Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...