What does 'SC726 Problem with finisher' mean on a ricoh aficio 2022

SC726: Finisher Shift/Lift Motor Error

Definition [B']

1) Tray shift does not finish within a certain time after the shift motor turned on.

2) The stack height sensor does not activate within a certain time after the shift

tray lift motor turned on.

Possible Causes

• Shift motor defective
• Shift tray lift motor defective

This is a problem with the finisher shift motor normally.

I do not have a manual for the Aficio 2022SP. However, there is a manual for the Ricoh Aficio 2022 available as a PDF here: http://www.ricoh-usa.com/downloads/local/manuals/multifunction_bw/aficio2022-27.pdf . If the direct link doesn't work, start here: http://www.ricoh-usa.com/downloads/downloads.aspx?d=pm and search for the 2022.

I hope this helps.

Cindy Wells

You could reset all the counters but you should call a proffessional with a good mantenance KIT, your copier probably needs it...

Have fun!

Hi, to change the IP address of a Ricoh Aficio 2022, follow these steps:

- Press the User Tools/Counter button.
- Choose System Settings.
- Choose Interface Settings.
- Choose Network.
- Choose IP Address.
- To specify an IP address, choose Specify, and then enter the address you want to use. To have DHCP automatically assign an IP address, choose Auto-Obtain (DHCP).
- Exit out of the User Tools screen.

The meaning of the error sc998 is the system software does not start within 60 sec.The cause for that is either the RAM, DIMM (software SD cards), firmware(system software) or the main controller is faulty or not connected properly.
Did you remove chip or SD card from the machine?

You must have a Ricoh tech ID in order to download machine firmware. You can get the firmware from Ricoh's tech website, TSCWeb.net if you have a valid Ricoh ID.

SC726 indicates a finisher shift tray malfunction.

Hi

Thanks for using FixYa. Error Code SC726 means the Finisher shift tray 1 lift motor error. You need to enter service mode and reset the unit by following the instructions given below.

To enter service mode (SP): Press the clear mode key then enter 1-0-7 hold down the c/s for three seconds. To enter the special service mode you’ll need to hold the # key down while pressing Copy SP. Exit service mode: by pressing exit twice. It will reset the and cycling the power.


Please do rate the solution and revert for further assistance.


Thanks
Rylee

Hello sir; The code sc545 means fuser unit temperature too low it can be reset;
press "clearmode" "107" and thenpress and hold "clear/stop" key untill display "copy sp" show up, then turn power off and back on.

Finisher shift/lift motor error. Could be caused be the tray or belt not being in the home position, a sensor, or a cable issue in the finisher section of the copier.