20 Most Recent
Ford 8N Tractor - Page 4 Questions & Answers
Need to wire selonoid 8n tractor
u can run a hot wire strait from coil to + side of ign switch, be sure and put a ballast resister in the wire to keep from burning out coils
Need to remove the oil pan on my 8N tractor
There may be a brace on both sides holding the pan,or the pan needs to be wedged off with a thin screw driver or a scraper.Use the thin edge of a scraper,or screw driver and tap it in with a hammer to cut the gasket loose.
I have fire at coil but no fire through sparkplug wires
The problem sounds like it is your distributor. Replace the ignition points and condenser, make sure the points are gapped properly. If you still don't get fire at the plugs, change the distributor cap, rotor, and wires. Points and condenser kit runs $9.72.
http://www.yesterdaystractors.com/ATK7FA_Ignition-Kit-4-Cylinder_14717.htm?gclid=CJzJscSG47sCFXPNOgod31wAqA
Set timing on 8n ford tractor!!
Does it have points?Use a 12V. test light on the dirstibutor terminal to + side of coil. When the test light goes ON,that is the timing at the crackshaft. Just like the old VW.
8N tractor
check your push button starter make sure it is working,or my be the points may be stuck
Not finding what you are looking for?