5701 VIPER 5701 2-WAY ALARM w/REMOTE START - Page 7 - Answered Questions & Fixed issues
Installed. Arm the car locked. About 2-3 hours
You must change the doors trigger connection if you have a negative input change it to positive input or vise versa and try. I’m sure that this is going to end your problems or the smart way is, take it back to Best Buy
I bought the car with wiper alarm system and
it may need to be programmed.......
-press the "f" button and hols for 12 seconds (ignore the beep at like 4 seconds.)
-press and hold the unlock button for 2 seconds...the remote should beep two times. each feature that is active will have an led light beside it. press the button to activate the feature. if the light is on the feature is on...
hope it helps...
I have a 2004 buick rendesvous. It will not turn
remove the fuses fromt the remote module (usually under dash. Also you can chase each connection back to the splice and remove the wires at the connections. Be sure to disconnect batt. before doing so.
Problem just started sunday...when the alarm is
I have the same problem. The easiest way around it is to disconnect the battery for 10 seconds and reconnect it. This will reset the alarm system, and the remotes will start working again.
Take note of your radio stations as they will reset. :)
Alarm light in dash blinks constantly, remote
did your install it yourself or did someone do it for you if either way man you may need to get someone to look at your wiring make sure everything is tired in right to your vehicle your power sources your ground everything your relay may be gone on the remote start in that case you can have that problem check your relay leading to your remote start
Replaced the battery in my car need to reset my viper alarm
Alarms are not supposed to shut down the engine while you are driving if it was installed properly. Could be another installed accessory or the car itself has a problem. If it was in anti-hijack mode, you would receive a warning like honking horn. You may have to visit a repair shop and maybe your local Viper dealer to have them take a look.
DC
I had the 5701 installed yesterday. The 2 way
The slow issue would need more explanation and what functions you are operating at the time. However, that is not a satisfactory excuse from an authorized Viper dealer. I would return to the dealer and explain the slow issue to the manager or owner. Otherwise, find your next closest dealer.
DC
My viper 2 way pager remote will not arm or disarm
It could be set on car #2. Press function for 8 seconds and a light next to lock should come on. If the light next to unlock and lock (two lights) then it is set to #2 car (you can operate 2 cars with one remote). All you have to do is press function again to toggle between the two cars. You want to end up with only one light showing.
So, hold function for 8 seconds, then after a light shows, release and press function until you only see the one light.
Remote keeps making low battery sound on two way.
We run into this a whole bunch at my shop. Take it back where you bought it and tell the shop about the battery drain. Those remotes had a problem and DEI has corrected the problem and you should have no problem trading in the remotes for new ones. It was a royal pain in the *** for me and i hounded DEI. I was told it was some loose solder on the board that caused the problem. hey, good luck and let me know if you have any problems. mark
Not finding what you are looking for?