5701 VIPER 5701 2-WAY ALARM w/REMOTE START - Page 3 - Answered Questions & Fixed issues
2005 sedona alarm
Please be more specific. Is it the factory alarm going off when you remote start or, is it the Viper alarm going off when you start the car with the key?
My car stop responding
Likely causes is the Viper's fuse has blown, the installation is faulty or the unit has failed. Without testing the system, it is not possible to determine the exact cause of the problem.
Remote start wont start the car
try hitting function twice so its at level 2 code and hit the unlock button, that sends it into remote valet mode. if that isnt it make sure the valet toggle switch is on and connected
My viper remote, no matter
Try this first, unplug the 2-way antenna on your windshield. Let it sit for at least a few minutes. Try recoding the remotes after you replug the antenna back in. This is an issue i have seen on some of the Viper units. Usually they never have issues, but here and there they need reset.
2 way viper lock light stopped working - how do i fix this?
It appears that the button is no longer making contact with the circuit board. There is pad underneath that may have shifted but, to repair is a pain and requires either a new shell or pad. It may be easier for you to purchase a new remote and program it to your system.
The alarm doesn't chirp and no flash of my
sounds like the alarm went into valet mode. that's usually what a solid blue light means on most viper alarms. check your owners manual on how to take the alarm out of valet mode. with the 5701 alarm its usually done with the remote. hope this helps
Lost my remote viper remote
Common issue.Open doorAlarm will be going offLocate the antenna (should be on the windshield)Find the little black push button on the antenna.Turn key to the ON/IGN position (where all lights are on)WITHIN 5 SECONDS push the black button 1 time and release (unless your installer changed the number of pushes it should be 1)Within seconds the alarm will ceaseStart your vehicle.If any other issues, send me a message.
My viper alarm came with my truck and i had to put
If theres a pattern for the time then it has a timer run time set. If no pattern the unit has activated either the temp sensor and/or the low battery voltage sensor. Check your owners manual how to deactivate.
Viper alarm keeps starting truck by itself
you have timer mode set. Check the time because there will be a pattern. Typically every 3 hours OR there is an automatic timer that will start based on the outside temp. sensor and theres one that monitors battery voltage and if the voltage drops to a low enough voltage the remote start will start.
Buying a car and the guy pulled out the viper
One has nothing to do with the other. The security system only interfaces with the starter wire. Just make sure the starter wire is reconnected and other than that its mechanical.
Not finding what you are looking for?