1995-1997 Chevy 1500 Truck Ignition Starter Alarm Switch - Page 5 - Answered Questions & Fixed issues
How to replace ignition lock cylinder with no key for 1997 chevy 1500 truck
mangle it out of there delicately as to not mess up the column, and or key reader if applicable,
if there is a chip in the key, remove the steering wheel and then the reader first
yours may have a small screw type bolt or long set screw that you remove right there also and the lock cylinder just slides out
there are special tools used to remove the retaining clip from the steering shaft that holds the steering locking plate since it is all spring loaded,
Does liquid glass work on transmissions its a 95 Chevy 1500
If you plan to permanently ruin your trans use the liquid glass
if it is a new transmission and leaking right from the start, there's most likely nothing you can do other than replace the torque converter support bearing behind it and the seal ,
if its been rebuild, I have seen the pump bolts loosen due to improper torque and the symptoms are the same and no sealer will work,
if its been a good trans and just needs some help, give it a fluid change with a new filter and add lucas trans seal and anti slip to the system and you should be fine in no time, maybe even another 10K miles.
What works best as a temporary fix from a front seal leak in tranny chevy 1500 95
if it is a new transmission and leaking right from the start, there's most likely nothing you can do other than replace the torque converter support bearing behind it and the seal ,
if its been rebuild, I have seen the pump bolts loosen due to improper torque and the symptoms are the same and no sealer will work,
if its been a good trans and just needs some help, give it a fluid change with a new filter and add lucas trans seal and anti slip to the system and you should be fine in no time, maybe even another 10K miles.
Wont crank cold
The white wire will only have voltage in the Off (bulb test), Run, and Start positons. It will not have voltage in the Lock or Accessory Position. When this wire's contact opens you will have no Tachometer, Speedomete, or Gear shift indicator. Also the Check Engine light will be on and Transmission will be usually stuck in 2nd gear (called limp mode). I installed an aftermarket replacement switch and it last 92 days. I am going back with the OEM replacement and now troubleshooting connections, Grounds, and Shift solenoids, tranny, Ect
1995 tahoe
Does black smoke come out of the exhaust pipe when you floor it? Is so, it is running rich. Make sure fuel pressure is with in limits. A bad regulator may permit too much pressure. Also check the MAP sensor. Make sure it is getting vacuum.
Not finding what you are looking for?