Remote Starter with Keyless Entry - Page 2 - Answered Questions & Fixed issues
When i juck the power, parking lights blink
IT IS IN SAFE MODE AND NEEDS TO BE INITIALIZED BY DOING THE FOLLOWING:
If you have a 4 button remote, you must ground the black/blue hood pin wire (raise hood if hood switch is installed). Apply 12volts to blue/black brake wire (press and hold brake pedal if wire is installed). Press and hold any button on your remote until clicking and flashing stops. Unit will now respond to the remote. Remove ground from hood pin wire and voltage from brake wire. If you have a 2 button remote, hold brake and press any button on the remote until clicking and flashing stops.
When I plug in the red power wires, the module
IT IS IN SAFE MODE AND NEEDS TO BE INITIALIZED BY DOING THE FOLLOWING:
If you have a 4 button remote, you must ground the black/blue hood pin wire (raise hood if hood switch is installed). Apply 12volts to blue/black brake wire (press and hold brake pedal if wire is installed). Press and hold any button on your remote until clicking and flashing stops. Unit will now respond to the remote. Remove ground from hood pin wire and voltage from brake wire. If you have a 2 button remote, hold brake and press any button on the remote until clicking and flashing stops.
I have a bulldog deluxe
With ignition on push and hold valet (programing) button for 2 seconds or untill remote beeps and z"s disappear.
When system is plugged in and i use my key half crank kicks truck
if you have the manual at hand, put key in ignition and turn to the on and off position fast as you can and then push button. it should not rrespond because thats resets the alarm, follow manual on how to reprogram! hopes it helps out. I have bulldogs rs 1200 and trying to unlock my doors via keypad. locking them with no problem
Not finding what you are looking for?