20 Most Recent
Craftsman 42 in. Deck 19.5hp Lawn Tractor - Page 5 Questions & Answers
How do I replace deflctor shield
You have to hold the spring and deflector in the loaded position (forcing against the spring force) while you feed the pin thru the deflector and spring and back thru the deflector and intor the deck bracket.
Replace belts on 917-271821
The deck has an idler pulley that keeps tension on the belt. The idler pulley is mounted on a pivoting bracket, that has a spring which provides the tension. You have to move the bracket so as to take the tension off the belt, thereby allowing you to slip the belt off the other drive pulleys
How to replace idler spring
You can either remove the deck first which will make the spring easier to get to or with the deck all the way down on the ground.
Need a wiring diagram for a rider 917255800
Brand ? Name ? Model ? Any other info ? Type of Engine ? Engine Model # , Type and Trim number ? How about the exact model number off the sticker from under the seat and in the same format including any hyphens or periods. Your number 917255800 comes back with zero hits until you provide further information.
MTD 42" zero turn transmission belt jumps left pulley on start
A little wd40 on each pulley arm assembly, make sure they move freely and good time to check the belt and belt brakes if equipped.
I assume your belt was recently removed or installed and is not following the correct pattern. Is this the issue ?
It's very common for people to install their belt around pulley in different direction and belt is not ( or is ) riding on the Idler pulley, other, or guides incorrectly.
Under the chassis somewhere is a label for belt pattern and is usually under the left side foot grip of the chassis.
( Lifting the mower ? )
Be sure to have some chunks of wood available. I use 2x4 and 2x6 scrap to hold up the machines without use of jackstands or any jack which causes damage.
Belt on craftsman 42" riding tractor
There should be a decal on the deck with the diagram. To change, first remove belt from engine pulley.(front pulley under emgine) and go from there.
Not finding what you are looking for?