20 Most Recent LG DLE2514 Electric Dryer - Page 2 Questions & Answers

If you need a new drum. Follow the instructions below.

Ordered drum from Sears parts. 3045EL1002D
Cost of 85$ + 15 to ship. It came in 5 days.

Here is how to do it on a DLE2514W. Takes about an hour. I only used a phillips screw

driver. Take your time and look over the situation. I hope that I rememberd

everything. Good luck.
Dryer Drum Repair

Dryer Drum Repair

1. Remove L bracket with 6 screws at the top, rear.
2. Slide top back 2 inches to unlatch and remove.
3. Remove control panel with 2 screws at top, inside corners.
4. Carefully unplug 4 plugs from back of control panel.
5. Looking at inside at the top. Remove wiring bundle from 2 guides.
6. Unplug wire from dryer light.
7. Open dryer door and unscrew 2 screws behind door just below lint trap.
8. Remove 4 screws at top of front panel that holds the door.
9. Lift up front panel to remove. I couldn't get the door switch plug to disconnect
so I carefully rotated it an set it on top of the dryer.
10. Remove upper case bracket with 2 screws in front and 2 screws inside at top.
11. slide up a bit to unlock from sides. Watch routing of dryer switch wire bundle.
12. Remove lint trap duct with 2 machine screws. Carefully slide down to remove.
13. Remove front drum support with 4 screws attached to sides. Lift up to disengage

sides. Lift drum to free from rollers.
14. Observe how drive belt is routed around motor and tension roller. Push tension

roller up and release belt. Carefully take belt off and remove.
15. Almost done. Lift drum up at rear to free from rear rollers. Remove.
16. While your're there vacuume up dust and reverse procedure to install.

no..

wheel bearings or bad belt.. woese case motor

Cool - no pun intended. The timer mechanism is not working properly.

There are more parts to check and figure out this issue. Check door switch, then temp thermostat.

This error code tell you the safety thermostat is not working. This part is on the top of element cover. Replace new one.

If the sensor was replaced but not help, the issue may be from control board. You do not say why you did replace a sensor, this part is hardly to be faulty.

Your question does not clear. When it cut off, does it still run or running without heat. If it is totally shut down, the issue may be from the motor as it was over loaded.

Check the door switch first.Than look for possible thermal fuse has cut off.