Peg Perego Gaucho Rock'in - Answered Questions & Fixed issues
Peg Perego Gaucho 12v has will not run
Check the wires to accelerator switch and the switch itself. I had problems where the switch has a high resistance when checked with a meter. When the switch is depressed, it should only read a few ohms. Any higher, it should be replaced.
8/20/2014 12:06:23 PM •
Peg Perego...
•
Answered
on Aug 20, 2014
•
569 views
We have peg perego Gaucho,gear
probably a bad/disconnected shifter switch first of all check to make sure that the shifter switch is connected underneath
9/21/2012 3:04:37 PM •
Peg Perego...
•
Answered
on Sep 21, 2012
•
325 views
How can upgrade my
you would need 24 volt motors and the circuit board, and shifter switch, and foot pedal switches
9/21/2012 3:02:04 PM •
Peg Perego...
•
Answered
on Sep 21, 2012
•
284 views
Peg pergo gaucho jeep won't go when push
first of all check for at least 12 volts from the battery and the charger, you can test this using a multimeter, if the battery doesn't show any volts, lift up one side of the blue plastic housing on the top and verify that both the positive and negative wires are plugged in, then check for power at the foot pedal, then at the shifter, then at the motors
9/21/2012 3:00:16 PM •
Peg Perego...
•
Answered
on Sep 21, 2012
•
737 views
Relay clicking
probably got a bad motor, are both rear wheels spinning in all of the gears?
9/21/2012 2:57:08 PM •
Peg Perego...
•
Answered
on Sep 21, 2012
•
73 views
GAUCHO A151 CANT GET IT TO GO
first of all check for the proper voltage from the battery and the charger, you can test this using a multimeter,
7/28/2012 12:22:08 PM •
Peg Perego...
•
Answered
on Jul 28, 2012
•
425 views
How do I remove the
you need 2 13mm sockets (deep). Remove caps on end of wheels, hold one socket tight and then undo (anti clockwise) the other then pull one wheel off and for the other - withdraw whole axle .
9/23/2011 12:44:16 AM •
Peg Perego...
•
Answered
on Sep 23, 2011
•
559 views
Not finding what you are looking for?