Just looking for possible setting numbers that give the best picture.
Colorimetre HCFR software
AVC HD 709 calibration disk
Spyder2 colorimeter (I know most prefer the Eye-One meters, but the Spyder2 was available from my job at no cost)
Here are the settings:
PS3 Blu-Ray player
Output Format (HDMI): Y Pb/Cb Pr/Cr (important!!! NOT RGB output)
BD 1080p 24hz Output (HDMI): On (this TV can reproduce video at 48hz for accurate 2:2 pulldown)
Y Pb/Cb Pr/Cr Super White (HDMI): On (not sure if this matters)
42LG50 Settings
Aspect Ratio: Set By Program (Personal Preference)
Picture Mode: Expert 1
Backlight: 50 (Personal Preference)
Contrast: 54
Brightness: 54
Sharpness: 40 (Personal Preference)
Color: 50
Tint: 0
Fresh Contrast: Off
Noise Reduction: Off
Gamma: Medium
Black Level: Low
Real Cinema: On
White Balance: Warm
Method: 10 Point IRE
10 (-3,8,-16)
20 (15,24,-21)
30 (20,36,-22)
40 (3,19,-40)
50 (8,34,-41)
60 (10,50,-20)
70 (-5,50,-8)
80 (-16,50,18
90 (-14,50,30)
100 (-22,38,21)
Red Color: -3
Red Tint: 0
Green Color: 10
Green Tint: 0
Blue Color: 14
Blue Tint: 0
Yellow Color: 0
Yellow Tint: 1
Cyan Color: -11
Cyan Tint: 0
Magenta Color: 0
Magenta Tint: -2
Take time to get used to the settings, you may think the screen looks dull at first. The truth is most people have way too much contrast on their TVs.
These settings will also work for Cable or Dish hookups, in which case you may change the Noise Reduction option to Medium to reduce signal noise.
OR....
2POINT IRE
Backlight: 65
Contrast: 55
Brightness: 45
Sharpness: 50
Color: 45
Tint: 0
Fresh Contrast: Off
Noise Reduction: Off
Gamma: Medium
Black Level: Low
Real Cinema: On
White Balance: Warm
Method: 2 Point
Red Color: 3
Red Tint: 0
Green Color: 9
Green Tint: 2
Blue Color: -1
Blue Tint: 0
Yellow Color: 6
Yellow Tint: 5
Cyan Color: -1
Cyan Tint: 1
Magenta Color: 2
Magenta Tint: -1
Posted on Oct 27, 2008
I TRIED CONNECTING IT TO THE LCD TV AUDIO OUTPUT JACK IT STILL DIDNT WORK....
Hi,
I have just brought the bose companion 3 speakers and i connected it to the headphone socket in my tv and it worked.
Hope this helps
Posted on Apr 15, 2009
i need to no how to reset the pass code on my lg 42inch hd lcd tv i bought used offline and dont have seller contact info ne more please helpppppppppp
Enter the password "7777".
Posted on May 28, 2009
How do I get the stand off my LG 42LG50 television?
On the back of the TV, there are 4 screws holding the stand. Remove the 4 screw and the stand will slide out from the bottom.
Posted on Jun 11, 2009
LG TV NOT TURN ON,MODEL#50PC3D-UD
SERIAL#604-RMVB013511
To let you know , there jave been may claims against this 42" model There were some models released that had faulty power boards and video controller boards. LG recalled many of these to have them replaced
No picture and sound is Y +Z Sustainer problem.However, normally they have to change both Y Sus and Z Sus boards atthe same time. If you lucky than it's just a fuse on the Y sustainerblown (the chance is very rare) otherwise the IPM (Intelligence PowerModule) on the Y/X sustainer board is short. This is a common problemand costly to repair.
Is it under warranty or Extended 5 year warranty? If so get it repaired now.
Call customer service for help 877-543-8325 to try them first
If you are skilled in electronics the cost of parts is about $250 online (Otherwise add another $400 for labour and travel if you use a tech ) Always ask for a quote first))
Just ensure you select the right model as i am unsure this link is correct one. But the place itself should have your model
http://www.electronica-usa.com/Merchant2/merchant.mvc?Screen=PROD&Store_Code=EU&Product_Code=6871VSNB03E&Category_Code=PLA
Please rate our help to =keep the FREE service online++++Thanks for using FIXYA
Posted on Sep 14, 2009
Does the LG 42LH30 (HDTV) have an auxilary audio output? If so, where is it located? Most TV's provide an audio output for hookup to remote speakers. Can headphones be used with this TV? I only found an extra set of AV inputs.
Tom
There is AUDIO Line out RCA jacks on the back, not speaker level output. You can get manual here: http://tv.manualsonline.com/manuals/mfg/lg/42lg50_1.html
Posted on Dec 21, 2009
tv will not turn on. No standby light or anything
There is a switch behind and under the screen on the lower right side of the set.
Just slip your hand on the right side, behind the screen in the lower end and you will find it. Switch the button on.
I hope this will help you.
Posted on Apr 02, 2010
how to reset a password
Set up blocking schemes to block specific channels, ratings, and external viewing sources. A password is required to gain access to this menu. Setting up Your Password For USA LOCK Move Enter Lock System : Off Set Password Block Channel Movie Rating TV Rating-Children TV Rating-General Downloadable Rating Input Block For Canada LOCK Move Enter Lock System : Off Set Password Block Channel TV Rating-English TV Rating-French Downloadable Rating Input Block Close Enter Password * * * * Select LOCK. 1MENU ENTER Input the password. 2 Enter the password as requested. The TV is set up with the initial password
"0-0-0-0".
Hope this helps
John
Posted on Sep 17, 2011
Just got an LG42 in TV unpacked it three days ago and it seems great Got home today to a plastic burning smell and it wasn't even on. watched TV for 3 hrs and smell is constant... TV has been off for 1/2 hr and smell is still in room. TV is NOT HOT no apparent problems and I can not see any cause ( no sparks, hot spots, or humming ) SO... what is it ??!!
I would contact the store you purchased it from,,,explain the issue and go from there...
Posted on Sep 20, 2017
I LOST THE SCREWS WHICH CONNECT THE LED TV SCREEN TO TV BASE STAND.SO COULD YOU PLS EASE ADVISE ME THE SCREW SIZES.
It is usually indicates on manual..
if you don't have manual try to go to retrevo.com..
Usually the common size 1/2 inch wood screw..
Posted on Jun 06, 2012
431 questions posted
Usually answered in minutes!
2,254 Questions
610 Questions
478 Questions
339 Questions
245 Questions