Crosley CCW5294W Top Load Washer - Page 6 - Answered Questions & Fixed issues

Check your load on rinse, if it increase on above motor speed then its could not spin.

Hello Colleen, I am happy to assist you! I see that you are interested in locating a service manual for your Crosley washer, CFW4500KW0. This type of data is very rare to find, however I successfully found the Owner's Guide, Installation Instructions and Parts Manual. Hopefully you find all the information that you are looking for. Best regards! Frigidaire Manual Search Results

If it is a top load washer. No have! Front loads one are to the bottom left or right on the door side. If you need further help, reach me via phone at https://www.6ya.com/expert/steven_b77d19396bfe2249

you have a loose pipe need to find it call the makers of your machine it should be still under cover let them do it

if water will only stop when you turn off supply to washer,you will have to replace fill valve.

change your inlet valve (hot and cold ) where the water supply hoses are connected to the washer Cheers

The hot or cold water valve where the hoses hook to the washer is not closing.

Have you checked the hose in the back it might be loose and it sounds like it is out of balence check the little feet that screw out and make sure its balenced and be sure not to over fill with clothing it may need to be rebalenced the drum

there are several hoses connected below all u can do is check them out u will see a water mark around were its leaking replac as nessary

You may download a copy of the manual at http://www.managemylife.com/mmh/lis_pdf/OWNM/1112431L.pdf

test capacitor with multimeter if u get no reading bad if it spikes then drops good

all the buttons go on when i shut the door except door lock button

It is so common that the washing machine can make terrible noise in many ways and is a common fault. In all occasions it is important that your observation is most important and so is vital to the identification /rectification and solution. If you have noticed that machine is vibrating when it is running then the motor /drum suspension has to be inspected. Since these fittings are located on the underside of the machine it is important that you look for the noise with a good inspection lamp. Manually turn the motor and drum and listen for the noise, if so the motor bearings, the drum agitator shaft and fittings must be checked. Also the suspensions which include the shock absorbers and springs, the body clamps must be checked to be in correct alignment and not changed in position. Tightening of the mounting is also very important. Finally in most cases a drop of OIL or smear of grease on the moving parts cane solve most issues.

Check this link :

http://www.espares.co.uk/advice/washing-machines/a/7/1210/wobbly-washing-machine-or-tumble-dryer.html

For replacement of bearings check for tips on this visual link: http://www.espares.co.uk/advice/washing-machines/a/7/1401/how-to-replace-the-bearings-on-a-washing-mach.html

What is the model number of your unit?

You will need to replace the lid switch. Here is the part to order.There is a video to show you how to replace the switch on that same parts page.

Hello - Does the drain pump make a humming noise? If so, you possibly have a restriction in the drain line or siphoning. Try setting the cycle to spin only and verify if water pumps out. If it does not, the unit could possibly be experiencing an issue with either the pump, door lock assembly or timer. Contact a professional to move forward accurately.

Hello - Does the unit make a humming noise? If so, either the drainage hose/pump is clogged and needs to be cleaned, or you have another issue with the door lock assembly or the timer and control board not communicating correctly.

Goes in the agitator in this:http://www.appliancepartspros.com/whirlpool-liquid-fabric-dispenser-63580-ap3048948.html If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Your washer is sensing the door is open...your door lock may be bad....also make sure the dispenser (where you put the soap.....is closed also)

Hello - What exactly is your concern? Is it dispenseing or not dispensing?