If the exact answer using part number, from Kenmore or whirlpool, a good close answer can be found as
https://www.whirlpool.com › blog › washers-and-dryers › large-capacity-dryers.html Large Capacity Dryers | Whirlpool
Most standard dryers offer between 5.0 and 7.0 cubic feet of capacity. To help translate cubic footage into real-life laundry loads, consider that a 7.0 cu. ft. dryer can usually fit about 9-15 full-sized bath towels per load. Exact capacity varies by model so be sure to check the manufacturer's recommendations.
There could be several reasons why this is happening. One possibility is that the timer or water line valve is faulty, which is causing the washer to stop mid-cycle. Another possibility is that the lid switch assembly has malfunctioned, which prevents the washer from spinning when the lid is open . Kenmore Washing Machine - Washer Stops Mid Cycle - Repair Parts ' Repair Clinic
I would recommend checking these components and their connections to see if they are functioning correctly. If you are not comfortable doing this yourself, it's best to contact a professional appliance repairman to diagnose and fix the issue
Reddithttps://www.reddit.com > tiedye > comments > does_a...
Aug 28, 2022 - I have a Kenmore elite that has a rinse and spin, but not spin only. ... Hold down the spin speed button on the elite for spin only. Upvote 2
6 answers · Top answer: I'll bet you have one. Look under lid sometime instructions there. Or look for a button ...
Missing: 417.41102000 select
Humming is the classic symptom of a Start/Run Capacitor that has failed. It gives the motor a jolt to get it going.
Just a little puzzled why spin works though :>/
..
Try resetting it....
To force reset a Kenmore washing machine, you must turn off the power and allow any juice inside the circuits to clear out. This is called a power cycle. Turn the machine off and unplug it or turn off power at the circuit breaker > press and hold the "Start" or "Pause" button for 5 seconds > wait about 5 minutes for the electrical charge to clear out of the washer > power the washer up again.
Great advice, @kcwasher_giy! My washer was doing the same and I called around for help. Basically what you said here is exactly what this appliance repair Kelowna BC company told me over the phone.