20 Most Recent
Whirlpool Calypso GVW9959K Top Load Washer - Page 5 Questions & Answers
Error code ( IE ) on my samsung washing machine model wa13g7q1
1E - WATER PRESSURE SWITCH ERROR
* Generated Frequency Signal of WATER LEVEL (WIL) SIW (KHz)
Normal Level = Abnormal W/L Frequency
Low Level = 30.00 Khz
High Level = 15.00 Khz
If the same signal is detected for more than 5 seconds, it is a PRESSURE SWITCH Error. When this error occurs the drain pump will operate for 3 min. and the display will show 1 E indicating a pressure switch error.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.
1/15/2014 5:37:02 AM •
Whirlpool...
•
Answered
on Jan 15, 2014
Cement counterweight broken
difficult to do much there. you could try gluing something to the bowl, but it is very unlikely to hold for many cycles. you can buy new outer bowl / frames from the manufacturer.
11/20/2013 5:26:43 AM •
Whirlpool...
•
Answered
on Nov 20, 2013
Display will not clear. washer will not start
If you had to replace blown capacitors on the control board, whatever took them out most likely took out something else on the board at the same time. Causes are many...lightning strike, moisture, bugs etc. I would look carfully at the board with a magnifing glass...you might get lucky and find a short you can fix. If not, your probably going to have to invest in a new control board.
11/17/2013 6:05:34 PM •
Whirlpool...
•
Answered
on Nov 17, 2013
Whirlpool calypso washer black streaks
to all that are having a problem with these calypso washers... if you have paid for a repair then you need to check out the lawsuit... calypsosettlement.com and see if it applies to you.
but if you are getting a mark or a residue on your clothes, then look at the inner wash plate gasket, where it meets with the outer stainless steel tub. if there is a gap between the gasket and the tub then thats where the marks are coming from.
it happens alot and thats not covered by the settlement, but its not too bad to replace the inner wash plate. you need to remove the cabinet, then the tub cover and the innerwash plate dome. then 6 screws and the cover will come off.
replacing the inner wash plate will solve the stains and get you a few more years of use until you have to buy a new washer as more items may fail.
10/23/2013 8:11:25 PM •
Whirlpool...
•
Answered
on Oct 23, 2013
What does ld mean?
ld mean long, drain. the machine was unable to drain out water in a given amount of time, calypso is imfamous for collecting lint in the pump assy, id open that up and have a look
9/25/2013 11:15:06 PM •
Whirlpool...
•
Answered
on Sep 25, 2013
Not finding what you are looking for?