Kenmore Elite 22.4 cu. ft. Bottom Freezer Refrigerator with Adjusta Cube Ice Maker - Page 5 - Answered Questions & Fixed issues
My Kenmore Elite bottom freezer
rewrwer
Sorry to hear about your problem. Sounds like you have a defrost issue. Hence your unit is not defrosting. All of this apply's if your freezer side has ice on it. If not. you have other issues
Here is a list of some things that can go wrong.
In addition, your drain tube maybe clogged
1. Defective heat coil
2. Defective defrost timer
3. Defective defrost sensor
4. Defective Fan
5. Defective compartment inlet damper (on some models)
You should call a service company to resolve your issue.
Since I tried to help you, Please help me and Rate/Vote on the response. Thanks
4 Thumbs - Very Helpful
3 Thumbs - Helpful
2 Thumbs - Somewhat Helpful
1 Thumb - Not Helpful
Getting dl error
If your not sure about the cooling yet I would say it's an electrical problem around the relay if u keep shutting it off the overload will kick in and well just buy a new one for all Yuri our gonna be paying im a student with 2 months to graduate just saying
How do I find out the model number of my Kenmore elite Fridge
Since the freezer is icing up there could be many different problems a blockage or a problem with the defrost or timer of the unit if u greeting unit number is should be on inside of the door or back by the condenser best bet from what I see is get a tech to fix it they will find all those numbers that u need
Help please - my Kenmore Elite Bottom Freezer not cold - top refrigerator getting warm.
Have pressure taps installed, & check the refrigerant... these refrigerators have a critical charge (meaning not a lot of refrigerant to make them work) So whoever puts gauges on it, make sure they purge their hose while screwing the hose on to the new pressure tap so there is no loss of refrigerant & no air gets into the system. It sounds to me like it is low on refrigerant.
Where is the defrost heater
Defrost heater is going to be very close to the evaporator inside the freezer section. Take the evaporator panel off that sometimes has the evaporator fan connected to it. There you will see a dark tube that bends back and forth with wire connections on each end. That is the defrost heater.
ICE CUBE MAKER SMELLY ICE CUBES
Hello margrek
Welcome,
YOU SAID, YOU HAVE KENMORE ELITE BOTTOM FREEZER WITH ICE MAKER THE ICE CUBES SMELL
HORRIBLE ALWAYS, I EVEN TOSS THEM OUT EVERY FEW DAYS, STILL SAME PROBLEM
Ice has bad odor and taste.
1• Ice has picked up odor or
flavor from strong food stored
in refrigerator or freezer.
2• Water running to ice maker
has poor taste or odor.
3• Ice not used frequently enough.
4• Cover foods tightly. Discard stale ice. Ice maker will
produce fresh supply.
5• Add filter to water supply line. Consult a water purifying
company.
7• Discard stale ice.
Huuum
Please remember to leave a rating!
5/25/2014 4:18:02 PM •
Kenmore Elite...
•
Answered
on May 25, 2014
•
3,921 views
Water is slow
Check to make sure water line valve is fully open near sink, make sure no crimps in water line, replace water filter if it is old (ie, more than 6 months).
Water not coming out
I have the same problem. It makes ice and the filter is new. There seems to be pressure when I push for water and a few drops come out. Any ideas please?
[email protected]?
Bad water & ice cube taste
then change your filter. the new filter could be different with the old filter. check the new filter, see if there is odor removal and taste removal with it.
if not then get the filter with carbon filter, odor and taste removal.
then with a new filter, run about 5 gallons of water before using the water for drinking.
tnx 4 using fixya,
drcool
Where is the defrost timer in a kenmore elite model 10654602300
I am pretty sure the defrost timer is built into the
8201528 Temperature Control Board If you have questions about the defrost control plese call Repair Clinic at 1-800-269-2609, 7 a.m. to midnight ET, 7 days a week They will be glad to answer any questions you may have. As for forcing defrost on your model I am still searching for a Service Manual that covers your model. If you suspect a defrost error on this model I would check the defrost heater and defrost thermostat before changing the
8201528 Temperature Control Board Here is a link to the
106.54602300 User Manual I do know that your model is made by Whirlpool and sold to Sears. You can find the parts breakdown for your model
HEREI will be here to answer any questions you have, Thanks
Sea Breeze
KENMORE ELITE MODEL #79577563600 FAILURE COCE
This is an error code for the icemaker fan motor.
If the control does not see a signal coming back from the fan motor you will get this error code.
Please see the image below from the service manual that explains the ER IF error code.
http://media.fotki.com/1_p,wkbwtkdqbqkgrkkxgtqsskgwtqkq,vi/ktfgsrbbdxktrrwffdr/1/1303472/5961857/image18067img-or.jpg
The ER IF code indicates a failure of the icing fan.
You may notice slower ice production but the other fans should be okay.
You can select the ultra ice option and see if the fan toggles on.
The fan or the control is bad.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.
Not finding what you are looking for?