20 Most Recent GE Profile WPRE6100G Top Load Washer - Page 7 Questions & Answers

there are balancers in three places on the side of the tub itself...one of them is probably stuck...free it up and you shouldn't have that problem anymore...if it broke off, then you will have to replace it. Here is the link to the part number and cost for the balancer ring https://www.geapplianceparts.com/GEApplianceParts/Dispatcher?REQUEST=ACCESSORY you should be able to get this part at any appliance parts store...or sears. hope this helps you

My parent's Hotpoint did the same thing!! The brake on the bottom of the tub is not engaging! It needs replaced!!

It sounds as though the electric solenoids in the water inlet housing (where the hoses attach to) are defective or burnt out!

The first thing I would check is to see if the drain line is shoved too far into the drain. If the drain hose is lower than the pump in the machine then you'll have a siphon effect going. If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

Most times this is a simple leveling problem. On bottom of all washers is little leveling legs, they turn out to raise and turn in to lower. Most the time as gravity spins, it is always better to have the front legs little higher the the back legs. Meaning have the back of washer a little lower then the front, it seems to carry gravity back and makes up for the gravitational force.

sounds like you need a circuit board, it is shorting out, thats why you can push buttons randomly and it works,,

4 flashes = Overfill fault presure pipe blockedCheck for high water pressure to unit, usually an indication of a bad water inlet valve.Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using Fixya, and have a nice day.

check the coupling between motor and the transmission it may be broke. if they break it will not spin. it is rubber to prevent a more serious problem. the cost is not that bad, well here in n.y.s anyway!

Hello,

In a perfectly normal washer with decent incoming water pressure it should take 3-5 minutes to fill depending on water level size selected.

If what your experiencing is that your washer does fill yet it takes forever the problem is going to be with the water inlet valve.


GENE