20 Most Recent
LG WM2487H Front Load Washer - Page 4 Questions & Answers
I have an error code
Hi
Error Upside F & E means thermistor error. To access the thermistor--
1. Disassemble the Back cover.
2. Unscrew a screw from the Tub.
3. Unplug the white connector from the thermistor.
4. Pull it out by holding the bracket of the thermistor.
Hope this helps... Please post back if you need more information.
Daniel
Getting a "te" error code -- a heating issue?
I had the tE or te error (an L with a line through it) error on my LG front loader and my local appliance store sold me the thermistor for $7. I layed the unit on its side and accessed the thermistor through the bottom. It plugs into the bottom of the tank. Blue and white wires. No screws and 1 tie-wrap. (Leave the rubber grommet in - just pull the thermistor rod out.) Works like a champ!
I get error FE- book
FE error means that the water is filling past it's set point. You may have a broken water valve that won't shut off when it's in the filling mode. You can check by running the washer and watching the water fill. If the water level fills above the bottom of the glass, you have a water valve that's not shutting off. Replace the water valve.
We have a LG washer,
Hi
This issue usually occurs due to kinked drain pipe, clogged
drain filter or drain pump. First make sure that the drain is not clogged and
remove clogs if present. If no visible lint is present then remove the lower
front access panel to check the drain filter and drain pump for any clogs,
you'll need to clean the drain filter and drain pump completely. Hope this
helps... Please post back for any further assistance.
Daniel
Hi...thanks for helping me first of all. The
hi kyliesmommy1,
I believe your drain motor is not draining the water. This has to happen before your unit will go to the spin cycle.
Please read the following tip, on how to clean the filter (It might just be an obstruction of some kind)
ACCESSING, DRAINING & CLEANING THE DRAIN PUMP FILTER
If this does not help, you might need to replace the drain pump - as it may have become defective.
Kind Regards
JEDEMEYER1
* I really hope this solution helped you, if it did please rate it.
It will not power on
Are you sure the outlet has power?
If so, then you may have to replace the control board. You will need to call the parts department with the exact model number and serial number for the current version control board.
Good luck
Washing machine Lg 7kg WD
Hello & Welcome to FixYa
LE error in your LG front load washer is displayed
when either the motor is not working or the control board thinks that the motor
is locked up. A Hall Effect sensor is used in these washers which monitors the
speed and direction of the motor and then forwards this information to the
control board. Hope you understand by now that this LE error is displayed when there
is an issue with the motor or when the Hall Effect sensor sends wrong signal to
the control. Conclusion is you'll have to check both motor and hall sensor and
replace the part# that is bad, usually I have seen the sensor going bad. Please
get back to me if you have any other questions.
Kevin
Not finding what you are looking for?