20 Most Recent LG WM2487H Front Load Washer - Page 3 Questions & Answers

Inlet water not coming in check tap valve at inlet valve there is one strainer clean otherwise inlet valve gone.

This has happened to me when the power has gone out. It doesn't display anything and all you can do is restart the cycle.

too much soap check settings.

Hi from retired Englishman in SW France,
That's 'te' standing for temperature error/ heating error. Before you call an engineer try emptying the washer then pouring a couple of kettles of boiling water into the drum and leaving for 30 minutes then see. Another thing is to empty a couple of packets of limescale remover into the drum together with a couple of kettles of boiling water (again!) and leaving overnight. It possibly needs de-scaling anyway ;-0) If these fail it will be an engineer call, sorry ;-0(
Good luck, John C

Two schools of thought here. 1st. the belt has slipped off the retention pulley. 2nd the belt has broken. Pull out the machine, unplug then remove back lower panel look under the drum to see the belt and pulley.

it means there is water leakage in hose connections or there is damage to the hose that results in water spilling or leaking.Your observation to the washer's inside is needed to confirm the leak and solve.check this link Leaking machine

that is a water level sensor is bad,. turn off water and unplug unit and call in a service tech.

the water valves are clogged with grit empty machine turn off the cold water tap leave it for 3 hours check drum for water if no water in your drum do the same to your hot water the 1 that leeks water into your drum is faulty replace the faulty valve

that means that the water is leaking from the hows at the back of the detergent drawer.

This is not a difficult fix, however the washing machine must be taken apart to access the detergent hose and find the leak.

Always better to call a technician.