20 Most Recent Irwin SDS-Plus Hammer Drill Bit 6in.L, 3/8" dia., ModelNo. 322024 - Page 5 Questions & Answers

no fixya doesnt --fixya doesnt sell products

check with the place you got drill from

try the place you got the drill

what brand is it ?most have a slide switch in top to put in hammer mode .might have a slide lever by the trigger for reversing

think perhaps a tiny magnet thru the chuck of mechanics metal finger thingy

open check as far as you can and look inside if there is a screw it needs removed all reversable drill have them and it will be a left hand thread

Is the belt nice and tight? Is the belt on the pulleys that are in line with each other? Does the pulley on top of the chuck spindle turn? The chucks are held in by a Morse taper, often there is a half moon key, on the shaft somewhere that is meant to shear if too much force is applied.

Contact Guardian Power directly to inquire.

Request the wiring diagram from Delta.

Contact Shopcraft and/or its distributor to inquire.

Contact Master Craft or its distributor to inquire. Alternatively, cross-reference an equivalent.

Contact Rexon directly to order the service manual.

Contact Shopmate or its distributor directly to inquire.

Contact Steel Craft or its distributor to inquire.

Cobalt bits are an upgrade from HSS because of 5-8% Cobalt in an alloy they work good in drilling in hardened or stainless steel. Carbide drill bits are tough too, but they are the most brittle bits. Carbide-tipped tools are usually used in masonry and stone. Full-body carbide bits are usually used in automated production only. Solid carbide drill bit So, actually, the answer to your question is to buy a cobalt bits.

The humming motor is that it could not get a turn direction because of only ac and a bad centrifugal or start capacitor if it hums try to turn it clockwise on the chuck to see if it will run .

No parts seem to be available. You would have to have one made in a machine shop. It appears that is was a hardware store brand. https://www.google.com/search?q=Cal+Hawk+model+240-2127+parts ..

Sounds about right!

hi jason try going to a car fan belt specialist ,, one that stocks many sizes..take your old ones in to match them with.. as an example search on line as i don't know where you are i can not give more specific info on location.. as an example this web site http://www.totalrubber.com.au/ or try repco car spare parts Rubber Hose PVC Hose Rubber Matting i assume your belt is an "A" size regards pete

Try fleabay.