20 Most Recent Ryobi 15" Electric Factory Reconditioned Trimmer (ZRRY41002) - Factory Reconditioned - Page 7 Questions & Answers

I think it is a small spanner you need to ajust it with

I set the crank pulley with the slot in the mag (shiny) section pointing up toward the camshaft (appeared to be top-dead-center looking thru SP hole). Set the deep hole in the cam pulley down to align with the crank slot. Slipped on the belt and surprise-surprise it fired right off. May need a bump one tooth either way, but too late to run it much tonight.

what do you do when there is no spark??????????????????
how do you fix???????????

form a gasket silicon gas resistent at any auto parts store about $6

turn the high mix screw just a little to the left it will have a letter H on one screw and L on the other

You likely are spot on with the diagnosis of bearings. But, I would hesitate to say that they are replaceable. Contact a local electric motor shop (alternator, starter, etc) to see if they would be able to change the bearings, and perhaps the bushings as well.

What is the model no. of the product. you are using.

Hi and welcome to FixYa. I am Kelly. When you say you stripped the cable I am assuming that your talking about the flexible drive shaft. This can be replaced at home. However,.... ou did not state if this was a gas or electric model. At the moment I am assuming it is a 25cc Gas trimmer. To replace the flexible drive shaft the motor will have to be unmounted from the drive shaft housing. It will have 4 flat sides on each end that must mate correctly into the slots of the motor and the power head or you will not be able to re-mount the engine.

With a good model number I can provide you with a source of the replacment parts and probably what mounting hardware that has to be removed to change the fl;exible drive shaft.

Thanks for using FixYa.

Kelly

You didn't list the model but those little rewinds are typically built very similarly.
It may sound a little crazy but it works, take the unit to a power washer such as a car wash and blow out the gook in the rewind with lots of hot soapy water and then rinse. Then using a probe or small screwdriver get the rewind unstuck. If it retracts you’re good to go if not let me know as you may have a broken piece in there and I'll need the model to know what to do next.

I have a whole 39 r wih a broken casting ( so handle is no longer attached to the engine body. tryong to get rid of it

Hi,Unless you are mechanically minded you can run into trouble it is best to get a quote from your local dealer.
Thank you.!