20 Most Recent XRS 9330 Radar Detector Questions & Answers

if you know someone who knows electronics and knows how to soljre than use his help or take it to the car service and they will find a new board.

i drove right past highway patrol with radar gun pinter at me and it didn't make a sound...its garbage..dont buy

X, K, and Ka Superwide are the radar bands that are used by police radar guns. X band was the first band used for by radar guns, but is now the least used. All radar detectors that we carry detect all 3 of these bands.

When any detector "detects" radar, it will produce some form of Audiable sound. If someone is speeding, they need to slow down IMMEDIATELY if they want to avoid a ticket. It doesnt really matter if the radar gun is x, k, ka, ku, etc. You will probably get a ticket if you dont slow down.

Most dectectors will have indicators lights or displays that indicate the x, k, ka, etc., radar signals are actually being detected. This can provide SOME useful information. THe letters simply designate BANDS of frequencies that are used to send the radar beams. It is similar to changing the channel on a radio - k and ka bands use HIGHER frequencies for their radar signals.

X band is the oldest radar band and it is used for police radars AND door openers at supermarkets and other locations. If you drive by a supermarket, your radar detector is likely to go off and it is almost certainly going to be X band. CHeck it out next time you drive by a supermarket with an automatic door opener.

Since the police and the radar companies like to play cat and mouse, newer radar bands have been invented that OBSOLETE the older radar detectors. When the K bands showed up in the police radar guns, the radar detector folks had to have a new product offering that would detect X band and K band. And the race continues to go on even today and now, there are LASER police speed detectors and the new "RADAR" detectors now need LASER detectors as well. If you want to know the exact frequencies of these "bands" (K, Ka, etc), let me know and I will send them to you. But they are operating in the tens of GigaHertz regions.

THX

r

it is turned on at the factory it cannot be turned on or off

The detector covers X,K,KA,V, and S. You can get the manual on link below if you need it.

http://www.cobra.com/downloads/manuals/XRS9300_manual.pdf

Good luck and please rate 4 thumbs for free answer

It is a radar detector detector. So if you are running a radar in a state where it is illegal, this technology can detect the presence of your radar detector and you can be pulled over and ticketed. This is done by detecting the local oscillators and other "RF leakage" from the radar detector.
Sometimes you may notice that when you are near another car with a radar detector, your radar detector may go off. There are situations where your own radar detector can detect leaking RF energy from another detector in a nearby car.

ok, stupid question but is the volume turned up?

X Bandwidth

POP is a type of radar mode which only a couple of radar guns have. In essence, radar gun in POP mode emits an extremely brief signal to measure a car's speed. This brief signal lasts for less than 1/5 of a second. POP mode can not legally be used to write speeding tickets since it is not as accurate as the radar gun's normal operating modes, and since POP mode provides absolutely no radar tracking history.

Most people turn off POP mode in their radar detector's options since POP radar is very rarely encountered and since users experience excessive false alerts with POP turned on.

Spectre refers to the Spectre radar detector detector (RDD) which police use to locate drivers who are using radar detectors. The current Spectre models in use by law enforcement are the Spectre III and IV models. Some Cobra radar detectors claim to be able to detect the Spectre I. This is of no value since all Spectre I RDDs have been upgraded to later Spectre models which Cobra radar detectors can not detect. In short, turn Spectre detection off since this feature is a needless source of false alerts.

VG-2 is a technology that police use to detect radar detectors. Detectors with this feature will detect when VG-2 is in use, and alert you to its presence.

AND

the x,k,ka codes you see flashing are......

X, K, and Ka Superwide are the radar bands that are used by police radar guns. X band was the first band used for by radar guns, but is now the least used. All radar detectors that we carry detect all 3 of these bands.

quoted by a professional at the Cobra industries for radar detectors, cb radios and electronics galore.
for more info see www.cobra.com