Description: Fuser reload error
This SC is issued if one of following conditions occurs: The fusing temperature rises 8°C or less in 1.5 seconds; and this continues 5 times consecutively. -or- The fusing temperature has not reached 45°C within 9 seconds (after the fusing lamp comes ON while the machine is warming-up). -or- The fusing unit does not attain reload temperature within 35 s. (normal temperature) or 65 s (lower temperature - the thermistor output is less than 18°C) after the fusing temperature control starts.
Noise aside, the most common cause of 202 codes on those things is the front door is not closed on the left hand side. It activates the laser shutter.
Mar 10, 2018
Several possibilities. Here are steps to take. First, shake the toner cartridge of this laser printer. Distribution of the toner could be the problem. Secondly, the problem might be a dirty Corona wire. That charges the toner so it sticks to the paper. Clean it by turning off the printer and unplugging it. Open the front cover and take out the toner cartridge. Locate the green tab at the top of the drum. Slide it back and forth several times. Return the tab to its original position. Reinstall the toner cartridge and close the cover. Plug it back in and test it out. Lastly, the problem might be the drum unit. Sadly, the fix for that is to replace the drum unit. Oops, I forgot to mention to check the settings to see what quality of printing they are set to. Good luck.
Bizcopier.myhttps://bizcopier.my > Information
To enter service mode, press the yellow Clear button, then 1-0-7. Then hold down the red Stop button for about 5 seconds. The screen will shift to a menu.
Does it take in paper and then jam there?
Open all the inspection doors. Remove paper trays. Remove all the toner cartridges. Use a flashlight and look for a small piece of torn paper and remove it carefully. Clean all feed rollers with a damp cloth. Reassemble and test.
https://www.google.com/search?q=Ricoh+MP+C5503+Paper+does+not+pass+front+of+fuser+unit
..
