20 Most Recent Maytag MFD2560HES Bottom Freezer French Door Refrigerator - Page 2 Questions & Answers

Look for a couple plates somewhere around the top and bottom of the door hinges. These can be pried off with a screwdriver. The bolts or screws will be under them.

this appears to be the door switch is either bad or disconnected and has triggered an alarm mode to the display. If the unit is cooling ok then you should remove and check the switch with a meter.

if this is a side by side...the drain is probable stopped up with debrie, causeing the water from the defrost cycle to fun out the front door, insetead of going into the pan underneath..

Pretty expensive, ($250+) make sure you need it

It's now April 29th and I'm probably WAYYY late on this one. First of all, I'm not certain that I have the qualifying answer, BUT here is what I believe could be wrong with your icemaker. I believe there is a fuse in the wire loom coming ouf of the icemaker that could be bad, and if it IS blown, possibility is greatest of a defective motor. Since these motors seem to rarely go bad, I'd be applying a "necessity is the mother of invention" technique and put your gray matter into looking for a commutator that turns this assembly a little deeper in the bowels of this assembly. Those little finger contacts CAN be corroded, but more often lose their tension, which will foul up it's operation. Hope this helps some, and my deep apology that I didn't spot this sooner to try and help you out. Sincerely, Fred

Yes that is your relay they are pretty common use your model number to track one down may tag is owned by whirlpool so most local places will have them

chances are the fan motor has quit have a tech replace it if this is not the problem it could be a sealed system issue or a defrost problem