20 Most Recent Whirlpool 24 in. GU3200XTP Built-in Dishwasher Questions & Answers

Hi,

The scum, film and white residue problems have started since the reduction of phosphates in dishwasher detergents.

Here is a tip that will help you to solve the problem of films, residue, and scum in your dishwasher.

Dishwasher Residue and Film on Dishes

heatman101

,./,./

Yup, found it on another site..I had the same issue today.

Reset code: Push 1. Heat Dry 2. Normal 3. Heat Dry 4. Normal

wait about 2 minutes as the controller resets itself. You should see all the leds flash on and then wash and rinse leds stay on for about 30 seconds. A minute or so later ..presto, my machine worked again.

My machine is not the GU3200XTP, but in the same Whirlpool tall tub series (same manual) so leds may not have the same name.

Mark

Is this hooked up to a insta hot under the sink? if so, the insta hot could be bad or the line coming from it could be clog meaning that there's no water coming into the dishwasher .

yust reset press heated dry-normal-heated dry normal-and it will work 100% remember that code it is reset code for wirpool quiet partner and many other models

Try this diagnostic cycle operation to reset. To start the Service Diagnostics Cycle, press thefollowing keys, in order, in less than 6 seconds, while in standby(power on but unit off):Heated Dry, Normal, Heated Dry, NormalTo Rapid advance one interval at a time, press the Start key, noting thatunlike Standard cycles, the Diagnostics Cycle automatically resumesafter door openings and does not require pressing Start to resume.Once the diagnostic cycle has run and shut off, run a normal wash cycle, empty and with no detergent, to reset the control to factory "normal" operation. Make sure there's plenty of hot water.

Whirlpool Dishwasher Won Start

1st check for food build up under the filter, just shine a flash light through the holes front left side at the edge of your filter. This area is the water intake for the wash arms.