Hoshizaki Freezer Commercial Ice Machines - KM900MRH Commercial Ice Machine - Answered Questions & Fixed issues
Hoshizaki F-450maf has no water in reservoir tank
If the Hoshizaki F-450maf ice machine's reservoir tank has no water, you should first check that the machine is properly connected to a water supply and that the water supply valve is turned on. You should also check that the machine's water filter is clean and not clogged. Additionally, make sure that the float switch is functioning properly and that it is not stuck in the "off" position. If these steps do not resolve the issue, you may need to consult the machine's manual or contact a professional for further assistance.
2/14/2023 8:15:39 AM •
Hoshizaki...
•
Answered
on Feb 14, 2023
•
375 views
HOSHIZAKI MODULAR FLAKER IS TRIPPING 1A FUSES WHEN TURN ON THE SWITCH.
Question edited for typo.
Question moved from Washing Machines Category.
Please don't type in all CAPS, it is considered SHOUTING and rude, plus harder to read.
You have a dead short to earth. Strip off all the panels and look for water where it shouldn't be and chaffed cables especially near holes in the casing. If you can't find anything, you need to check individual items, compressor, pump, and grinder with a multimeter. Or just call for service.
2/8/2023 4:06:01 AM •
Hoshizaki...
•
Answered
on Feb 08, 2023
•
117 views
Hoshizaki ice machine beep 3
in the freeze cycle too long. Most common is the water valve leaking through. Second thing to check is for a stuck float switch.
4/19/2022 11:35:44 PM •
Hoshizaki...
•
Answered
on Apr 19, 2022
•
11,195 views
I need a copy of the service & cleaning
Factory phone number is 1-800-438-6087
They may supply it for you, or give you contact information for the nearest contracted service representative.
3/22/2022 12:39:23 PM •
Hoshizaki...
•
Answered
on Mar 22, 2022
•
109 views
Kml 400 mae water pump
hoshizaki ice maker kml 400 mae is not making enough ice after i cleaned it.
12/17/2017 8:09:28 PM •
Hoshizaki...
•
Answered
on Dec 17, 2017
•
398 views
What happens if you would add a charge to a
as long as you recovered the charge, pulled a vacuum, changed the filter/dryer, and added the correct amount of refrigerant as a liquid, you should be good to go.
7/7/2017 11:46:42 PM •
Hoshizaki...
•
Answered
on Jul 07, 2017
•
891 views
Why is my ice machine compressor over heating
usually from not enough refrigerant in the system. compressor overworking. excessive heat could also be from the compressor being bad such as bad valves. should be checked out by a service tech as this could involve removing freon to make repairs.
6/17/2017 11:26:16 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
•
431 views
I have a Hoshizaki KM900MRH
float switch is usually a white plastic unit with a black rubber boot on the bottom. you need to drain the water out of the sump before doing anything with the float.
6/17/2017 11:19:57 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
•
265 views
I have two Hoshizaki km-1600
this machine is rated for 1,600 pounds of ice in 24 hours. would need more info to offer suggestions.
6/17/2017 11:16:48 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
•
158 views
Where is the reset for
most all machines by Hoshi, the reset button is on the control board. take your time and look at it as it is labeled but is very small.
6/17/2017 11:14:37 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
•
221 views
Ice machine is on, but
this could be a large range of issue and too many to list for someone who may not be a skilled technician. I strongly suggest having a tech check it out as it may get into removing freon or more to make the repair. Sorry for the news.
6/17/2017 11:12:54 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
•
128 views
Why does my KML-600MAH only make water not ice?
Check to see how long it stays in the freeze cycle. normally it takes a least 20 minutes to make a batch. If less than that, you are probably loosing water causing an early harvest and almost no ice.
6/17/2017 11:08:35 PM •
Hoshizaki...
•
Answered
on Jun 17, 2017
•
177 views
Not finding what you are looking for?