20 Most Recent Husqvarna 150BT 50CC Gas Leaf Backpack Blower 180 MPH - Manufacturer - Page 6 Questions & Answers

Does engine crank (starter engages) or no crank when you turn key to start?

If no crank, what is the battery voltage?

Engine crank requires the following;

Brake ON
PTO OFF
Ignition switch to start position.

The seat occupied switch energizes the operator presence relay. This relay allows power to the PTO clutch from the PTO switch only when energized (operator in seat).

A simple test

1.PTO switch OFF
2.Ignition switch to ON position.
3.Engine not runnjng
4.Operator in seat

Pull PTO switch. You should hear the the clutch engage with a notable pop. Then turn off PTO and it will make another pop or clunk when it disengages.

Similarly with PTO engaged, if you rise from the seat it should disengage.


Also a failed charging system may allow the engine to start and run but not provide enough current to properly engage the electric PTO clutch. With engine running check battery voltage is greater than 13VDC.

Please try to reach out with the manufacturer.

How to replace real akel

I have the same question. Aside from dropping the transaxle, drilling holes in the plate behind the transaxle may be the best approach. See https://www.youtube.com/watch?v=DxV7grseBtA I also have a bad shock/dampener on the forward/reverse actuator. Verified by removing the bottom clip and moving the shock rod up and down. It had no resistance and there was evidence of oil loss. Failure of the shock causes abrupt lurching during stopping unless you're very cautious with the forward reverse peddles. I plan to tackle both jobs this weekend and I'm hoping that I can drill holes to get access to both oil fill plugs and the top of the shock.

Question edited for clarity to what I THINK you meant to say. I presume you mean a Husqvarna, you missed out the word 'belt', so I guessed it :>D I moved from the Hewlett Packard Computers Category to Husqvarna Riding Mower. The manual will always give you the belt routing diagram. There are videos as well. https://www.google.com/search?q=Husqvarna+Platinum+Series+LE+belt+routing

Download Manuals & Illustrated Parts Listings - Husqvarna

https://www.husqvarna.com > ca > Support

Search for Manuals and Downloads at Husqvarna. ... Owner's Manuals & Illustrated Parts Listings. Enter product. Search. Be the first to know. ..

might be a seized bearing

An engine needs three things Fuel Compression A spark at the right time The battery is only needed to turn it over. New spark plugs properly gapped is good. A fuse only needs replacing if it has blown, and first, you must find out why it blew. If it 'rotated', then it did 'turn over', you mean it didn't start. Did it spark though? Remove the plugs and hold them connected against a solid earthed part of the engine. Turn the engine over, do you see a nice fat blue spark? I think you probably need professional service. ..

Check the leftside manual transport bypass lever has not somehow engaged. Compare it to the right side.The two transaxles are driven by the same belt so extremely unlikely it's a belt problem.Look for any signs of fluid leaking from the left transaxle shaft seal. If the seal has been leaking then it may be low on fluid. The transaxles are considered maintenance free so there are no instructions from Husqvarna for adding fluid but it can be done. However, if the shaft seal is leaking it will need replaced.See operators manual regarding bypass levers (rods).https://www.manualslib.com/manual/74128/Husqvarna-115-127127-Ir.html

Normally, you just go by the Briggs and Stratton engine and model numbers. B&G carbs https://www.google.com/search?q=replacement+carburetor+for+a+18.5+brigs+and+Stratton Or Walbro https://www.banggood.com/buy/briggs-stratton-carburetor-walbro-697202.html I would be surprised if Jack didn't have one!

Briggs and Stratton 31E707-0111-E1 Parts Diagram for ...

https://www.jackssmallengines.com > briggs-stratton > c...

Briggs and Stratton 31E707-0111-E1 Carburetor - Walbro &Nikki, Cylinder Head, Fuel Supply, Kit - Carburetor Overhaul - Walbro & Nikki Exploded View parts lookup by model. Complete ... (Carburetor Part Numbers 696179, 697202). $6.18. https://www.google.com/search?q=Walbro+697202 ..

Model number?

Check the carburetor anti afterfire solenoid was not disconnected or otherwise disabled while "cleaning".

Kawasaki FR730V

Spark Plug
NGK BPR4E6
.030"
16 lb/ft

It is shown here in the Manual https://www.manualslib.com/manual/502540/Husqvarna-Yth20k46.html?page=27 ..

ever check the fluid level . they do not like air .

sounds like the where the oil comes out is gummed take the chain off and clean the hole out.

Check transaxle bypass is closed (rod is all the way forward).

Check transmission drive belt and linkage from right foot pedal to transmission.

take it to your local dealer for their help many thinks have to be seen by the fixer which we can not do

for you own safety fix it right.

White smoke is water vapor (steam) Blue smoke is oil Black smoke is rich mixture Best guess is that you have a blown head gasket.