20 Most Recent
Craftsman WeedWacker Gas Trimmer 25cc 2-Cycle Curved Shaft - Page 2 Questions & Answers
LT 100 craftsman riding lawn mower 17.5hp what all can cause the engine to turn over slow?
Clean the battery posts and the connectors with a wire brush and then smear them with Vaseline. Tighten the connectors well. Take of the negative ground to the chassis and do the same with that.
Also take the battery to an Interstate Battery outlet and ask them to load test the battery. Voltage is one thing but Cold Cranking Amps (CCA) is the important part of a battery. They do it for free and it takes 2 minutes, and you get a printout, CCA on the battery to CCA Actual.
..
Tiller will not start. This is a hard one.
Caveats when using starter fluid.The carburetor must not flood the cylinder with fuel. A flooded engine will not fire, even on starter fluid. If you're not sure, pinch off the fuel line and drain the carburetor bowl. Remove the spark plug and pull recoil several times to dry out the cylinder.Remove air filter, set choke full open, spray a short burst of fluid directly into the carb throat. Promptly pull starter.Use a new dry spark plug. If it does not fire, try gapping plug 0.005" shorter and repeat above procedure.Comment for further assistance.
Craftsman T1200 Mower. Which holes do the deck pins go in please?
The location of the deck pins on your Craftsman T1200 riding lawn mower may vary depending on the specific model and year of your mower. However, here are some general steps you can follow to identify the correct location of the deck pins:
1. Examine the deck and the mower: Look for any markings or labels on the deck that indicate the location of the deck pins. Some mowers may have a decal on the deck that shows the correct placement of the pins.
2. Check the owner's manual: Refer to your owner's manual for specific instructions on how to install the deck and where the pins should be located. The manual should have diagrams or pictures that show the correct placement of the deck pins.
3. Use trial and error: If you're unable to find any markings or instructions, you may need to use a process of elimination to identify the correct location for the deck pins. Try inserting the pins in different holes and check to see if the deck is level and secure. If not, try a different combination of holes until the deck is properly secured.
Keep in mind that it's important to ensure that the deck is properly installed and secured before operating the mower. If you're unsure about how to install the deck or where the pins should be located, it's best to consult a professional mechanic or contact Craftsman customer support for assistance.
Not finding what you are looking for?