20 Most Recent Kenmore 6.7 cu. ft. Electric Dryer - Page 2 Questions & Answers

make sure the water is turned on to the unit.

unplug--see if it resets--if not--the control box is bad--about 300 for the part Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/david_2f6e03df6c124197

sounds very like the bearing are gone i am afraid not good news its quite expensive to replace them if your machine is splitable

Appliance Repair Forums Near top of page click on Thread "HE Error Codes" Even blonde can do it Quick fix repair for Kenmore He2 front loading... Search youtube for he2 washer for other help videos

Through the lower tube of the tub may be able to remove the item of clothing.

I have not got a sol yet.

F28 means your washer is locked and not unlocking. To unlock your washer take off the bottom access panel by removing the 3 bottom screws. Reach up near the latching assembly & attached to the door latch is a little plastic pull lever. Pull down on this lever and open the door. Unplug your washer for 60 seconds and plug your washer back in. If the error re-occurs you need to replace your door lock.Click if helped.

It is possible that the machine does not start off the cycle because there are errors due to feedback from the inputs. For the program to start up the main program controller must initiate the INLET/MOTOR/DRAIN pump/ valve to open up and allow each function to be driven starting from the flow of water into the drum as also the drain valve to open to exit the water at the point of the program cycle. If this does not happen then the voltage at the valve/motor/pump must be checked or the fault relates to no voltage from the controller. This means the controller is a suspect.

If the water flows though the inlet then the flow pressure should be good, if not the inlet valve is bad or there is dirt in the filter. Also check the flow at the inlet of the water line. Once the water comes into the system the WATER LEVEL SENSOR - normally a pressure switch- must activate at the preset/chosen level to give the signal to the program controller to switch on the motor. What is most important for the motor to start functioning is that the door switch must be ON when the door is shut or this will be an error for starting the motor for rinse and wash.

Check this link to replace the inlet valve: http://www.espares.co.uk/advice/washing-machines/a/7/1408/how-to-replace-the-inlet-valve-on-a-washer-dr.html