20 Most Recent
Toshiba E-Studio 3040c Copier - Page 7 Questions & Answers
How to reset error code C452 in the Toshiba e studio 2006
1. Turn ON the power while [0] and [8] are pressed
simultaneously.
2. Key in "2002", then press [START].
3. Change the current status counter value "62" to "0", then
press [OK] (to cancel [C452]).
4. Turn the power OFF and then back ON. Make sure that the
equipment enters the normal ready state.
TOSHIBA E-STUDIO 347CSL how i make it work without toner chip
You can't. It is made that way. You can reprogram the chip if you can find the machine and the software to do it. Everything is done to make you use OEM original toner cartridges, which are better quality, more reliable and made especially for your machine.
Toshiba e-studio 3008 show f101 call for service error 13 . How can i solve it?
1. Turn the power of the equipment OFF and check the
connection of the HDD.
- Connector and harness check
- Check if the connector pins of the HDD are bent.
- Check if HDD for other equipment is not installed.
- Check if SRAM for other equipment is not installed.
2. If the error still occurs after step 1, perform the following.
- HS-75 File System Recovery mode ? Recovery F/S ? /
imagedata, and then restart the equipment.
- Perform FS-FAX ? 11 FAX CLEAR MODE ? [CUSTOM
INITIALZE] ? [CLEAR DATA], and then restart the
equipment.
3. If the error persists after step 2, perform the following.
- Perform HS-73 Firmware Assist mode ? Format HDD, and
then install "System Software (HD data)" with HS-49
Firmware Update mode.
Notes:
The following items will be deleted by performing HS-73
Firmware Assist mode ? Format HDD.
• Message Log
• Job Log
• Spool Data (Print, Email reception)
• Template
4. If the error persists even after step 3, perform the following and
then reattempt step 3.
- HS-74 HDD Assist mode ? Revert Factory Initial Status
HDD.
5. If the error persists even after step 4, replace the HDD.
6. If the error persists even after step 5, replace the HDD
harness.
7. If the error persists even after step 6, replace the SYS board.
Not finding what you are looking for?