20 Most Recent Indesit W 123 Front Load Washer - Page 8 Questions & Answers

Type your washing machine name into the Google search box and scroll down the list of 'hits'. You'll see your washing machine instruction booklet offered for free as a PDF which you can download in a couple of seconds.

Click this link : Door lock

Click on: Door locked

Click this link: Door lock

unless the pump is just blocked ( remove blockage ) the pump cannot be repaired only replaced with a new one .

Possible that the DOOR lock SWITCH is faulty and so the continuity to the switch and the wiring to the panel must be checked.If there is no continuity then the switch must be replaced.

your machine has a filter on the bottomn roght hand side looks like a black plastic knob..torn this anti clockwise watch out for water coming out of it have some towels ready clean it out and thaen out it back on turn clockwise and that should sort it out hope this helps

Error code F08 means that the heaterrrelay cannot be activated.
Check the connections to the Pressure switch, the Module,and the Heater element.
If you can, test the element of the heater to make sure it is o/k.
Hope this helps.

Check the fuse in your washer's plug.

Sounds like possibly the main drum bearings have seized.
To check, remove the rear panel of washer, remove the drum belt, and try to turn the drum by hand, if it is noisy or rumbling, or not turning at all, then likely the the drum bearings have seized.
This is a major repair, and could be expensive!!!

Is the machine siphoning off water as it fills? If it is check the height of the drain hose and make sure it is above the height of the normal level of water that would be in te drum when washing, if the hose is to low the drum will siphon off the water on its own and continue to fill. If the machine is not siphoning off water while filling then you may have a blocked pressure hose or the pressure hose bottle may be blocked not allowing the pressure switch to activate. there may even be a small hole in the pressure switch hose. Check the thin pressure hose that goes from the bottom of the drum to the pressure switch.

Hang on a minute guys, She said it washes perfectly so there is NO PROBLEM.Front loading machines should only have LOW SUDS powder put in them to PREVENT LATHER. Excess Lather / foam WILL leak out and WILL ruin the machine.

you have a faulty water valve turn the cold water off at the main see if the water is still dripping in if it is it will be the hot water valve replace faulty valve they are fairly cheap to buy best to replace both piece of mind you can buy them on line and are easy to replace euro spares will have them if you still need help let me know.