20 Most Recent Indesit W 123 Front Load Washer - Page 6 Questions & Answers


Sounds like water pump problem pull apart clean or replace

Indesit W 123... | Answered on Nov 02, 2013


You probably have a restriction in your drain down line of the sink-our sink does this because of the size of the discharge hose we run out to the garden to use the water for the garden-so you may want to have a plumber snake out your line-cheers Denny

Indesit W 123... | Answered on Oct 24, 2013


Reset the machine by unplugging and see if that will help.

Indesit W 123... | Answered on Oct 15, 2013


try ranson spares, there good at most things,,otherwise e-bay, most outlet hoses are pretty universal

Indesit W 123... | Answered on Sep 10, 2013


you will need to remove the pulley first, the screw in the middle will need a knock to release the loctite.
you will then need to remove the spider assembly, that's the metal cross the bearings are sitting in. there are bolts set around the drum. spray the bearings shaft with oil to help removal, and you may need to hammer the spider as you remove it to loosen it. be careful of the heater.
then knock the bearings and seal out and do the reverse proceedure to put back together.

Indesit W 123... | Answered on Sep 10, 2013


Your machine may not be receiving adequate voltage to start. Make sure your machine is plugged in. Also, check the circuit breaker panel to make sure all the circuit breakers are in the correct positions. Or check to make sure no fuses in the fuse panel are blown. Try plugging something else into the same outlet. If it won't work either, then there is likely something wrong with the power outlet. Any of these could be the reason power is not getting to your machine. Also, refrain from using an extension cord to plug your machine in.

Indesit W 123... | Answered on Aug 25, 2013


Try moving your drain hose to a different height.t may need lower than you have it. My washer did the same , Drain hose needs to be higher than the pump that drains the washer.

Indesit W 123... | Answered on Aug 17, 2013


Check your fault codes. I have had to raise the discharge hose to 1" to 1 1/2" above the back of the washer, then connect to the drain tube. Height of the discharge hose can cause cycle to not operate properly, like fill and drain at the same time and won't cycle properly.

Indesit W 123... | Answered on Aug 17, 2013


This usually indicated a problem with the pump. There is a belt which turns the agitator, spins the drum, and turns the pump, which is what removes the water. Since the agitator works and the drum spins, the pump is probably faulty.

Indesit W 123... | Answered on Aug 02, 2013

Not finding what you are looking for?
Indesit W 123 Front Load Washer Logo

1,189 questions posted

Ask a Question

Usually answered in minutes!

Top Indesit Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

peter gittos
peter gittos

Level 2 Expert

247 Answers

jimorris77

Level 3 Expert

411 Answers

Are you an Indesit Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Indesit Washing Machines

  • Indesit Washing Machines

Most Popular Question

washing machine will not drain

  • Washing Machines
Loading...