20 Most Recent
Behringer XENYX 502 5-Input 2-Bus Analog Mixer XENYX 502 - Page 9 Questions & Answers
On a behringer xenyx 2442 mixer there are 3 mute
According to the manual, the mute buttons don't affect the AUX sends. Depending on how you've got it set up, this might be the issue. The block diagram shows how the signals are routed. Or maybe it's just broken. Behringer has a good warranty program.
Behringer SL3242 Mixer has a noise problem.
It sounds like you have ground loops. This is noise generated by having interconnected equipment grounded at different physical locations. Especially a problem if you have a cable from your cable TV provider connected into your equipment.
Remove EVERY connection into and out of the mixer. Plug in headphones. Noise? If so, mixer needs repair. If not, re-connect equipment 1 piece at a time and assess for noise. If it slowly increases as you add connections you will need expert on-site help to fix it. If it is sudden, what was just connected is the source and steps need to be taken to lift the ground on the connection to that equipment.
I have an analog amp connecting several mikes. I
try to connect (ground loop isolator)code number(270-054).you can get it from any radio shack near you.
and connect it between your sound source(amplifier in our case)and the computer line in(your sound level in amp is around 0db)
Just starting . how to use and understand
Why don't you take a look at the manual?
If you don't have it, you can find it
here.
Is that what you were looking for or do you need explanations for things like EQ, Pan, Frequency, etc.?
If so, let me know and I'm happy to help.
In general: I worked with Behringer equipment a lot and always liked it. No fuzz, solid built and good sound.
I bought a new behringer vmx1000. I can not get
What microphone are you using, and also have you checked the cable is good? The gain knob on the mic channel is the only independent control for the mic level in relation to the music (without altering the masters). Also, you need the mic to be enabled on the channel, using the Mic On switch. Yours might be labelled On Air, Mic Live, etc.
Bass amp speaker
Just order new drivers ( speakers ) from the driver manufacturer, or any manufacturer as long as the size and ohms are same as original, look at back of speaker on top of magnet end and there's usually the manufacturers name, can probably order new drivers from their website.
Behringer Vintiger GM110 guitar amplifier Output pcb board
You should be able to get a diagram from the company itself and the circuit board can either be purchased from the manufacturer itself or they can tell you who to call.
Here is the manufacturer's number
BEHRINGER USA
BEHRINGER
USA Inc.
18912 North Creek Parkway, Suite 200
Bothell, WA 98011
Tel.: +1 425 672 0816
you can also try their online support at
http://www.behringer.com/05_support/webform_support.cfm?lang=ENGbut I would just call them, it would be much easier
Let me know if you need any further help or if they couldn't help you and I will let you know who else might have what you need.
good luck
Audiosonic CR-06PL not changing time when following manual instructions.
Set Time Hours and Minutes: Press Time/12/24 and Alarm1/ON/OFF buttons at the same time for two seconds and it will start to blink the hour.
Press and hold the button for a fast setting or tap it briefly to increase the setting by one hour. Now set the minutes with time (press and hold) and min.
How do I set the Audiosonic clock? Set current time Press and hold the time button and simultaneously press the hour to set the hours in 24-hour mode .
Not finding what you are looking for?